User manual SONY XR-C6100R

[. . . ] This unit lets you enjoy a variety of features by using a rotary commander. In addition to the tape playback and the radio operation you can expand your system by connecting optional CD/MD unit*. * You can connect to an CD changer, MD changer, or an CD player, MD player. Playing tracks repeatedly -- Repeat play . [. . . ] Note that turning the "AF TA" function off stores RDS stations as well as non-RDS FM stations. You can preset the volume level of the traffic announcements beforehand, so you will not miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. Presetting different settings for each preset station Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Press the desired preset number button for two seconds until "MEM" appears. Repeat from step 1 for presetting other stations. If an emergency announcement comes in while you are listening to the radio, the programme will be automatically switched to the announcement. If you are listening to a source other than the radio, the emergency announcements will only be heard if you set AF or TA to on. The unit will then automatically switch to these announcements no matter what you are listening to at the time. Tip If you want to change the preset AF and/or TA setting after you tuned in the preset station, you can do so by turning on/off the AF or TA function. You can locate the station you want by selecting one of the programme types shown below. Note If the countries or regions where EON data is not transmitted, you can use this function only for the stations you have tuned in once. Press (PTY) during FM reception until "PTY" lights up on the display. "--------" appears if the received station is not an RDS station or if the RDS data has not been received. The programme types appear in the order as shown in the above table. When the unit finds the programme, the programme type appears again for five seconds. "NO" and the programme type appear alternately for five seconds if the unit cannot find the programme type and it returns to the previous station. By receiving CT (Clock Time) data, the clock of this unit can be set automatically. During FM reception, press (2) while pressing (SEL). notes · The CT function may not work even though an RDS station is being received. Note You can not use this function in some countries where no PTY (Programme Type selection) data is available. Using the rotary commander the rotary commander works by pressing buttons and/or rotating controls. [. . . ] Outputs Telephone ATT control lead Power amplifier control lead Rear line out (1) Front line out (1) (XR-C6100R only) Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 2 kg Parts for installation and connections (1 set) Rotary commander RM-X4S Front panel case (1) Bus cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) RCA pin cord RC-63 (1 m), RC-64 (2 m), RC-65 (5 m) CD changer CDX-705, CDX-605 (10 discs), CDX-T60, CDX-T62 (6 discs) MD changer MDX-60, MDX-61 Source selector XA-C30 Design and specifications are subject to change without notice. The following checklist will assist in the correction of most problems you may encounter with your unit. Before going through the checklist below, refer to the operating procedures. [. . . ]