User manual SONY XR-C7200R

[. . . ] There must be a distance of at least 15 cm between the cassettes slot of the unit and shift lever to insert cassette easily. Choose the installation location carefully so the unit does not interfere with gear shifting and other driving operations. [. . . ] This unit is designed for negative ground 12 V DC operation only. Connect the power connecting cord 8 to the unit and speakers before connecting it to the auxiliary power connector. Run all ground wires to a common ground point. Connect the yellow cord to a free car circuit rated higher than the unit's fuse rating. If you connect this unit in series with other stereo components, the car circuit they are connected to must be rated higher than the sum of the individual components' fuse rating. If there are no car circuits rated as high as the unit's fuse rating, connect the unit directly to the battery. If no car circuits are available for connecting this unit, connect the unit to a car circuit rated higher than the unit's fuse rating in such a way that if the unit blows its fuse, no other circuits will be cut off. Anslut strömkabeln 8 till enheten och högtalarna innan du ansluter den till den yttre strömanslutning. Om du seriekopplar enheten till andra stereokomponenter måste den bilkrets de kopplas till ha en högre ampere än summan av de enskilda delarnas amperestyrka. om det inte finns några bilkretsar med en så hög amperestyrka som enhetens ska du ansluta enheten direkt till batteriet. Om inga bilkretsar finns för anslutning till enheten ska du ansluta enheten till en bilkrets med en högra ampere än enhetens styrka så att inga andra säkringar går om enhetens säkring smälter. If your car has no accessory position on the ignition key switch -- POWER SELECT switch The illumination on the front panel is factory set to be turned on even while the unit is not in use. However, this setting may cause some car battery wear if your car has no accessory position on the ignition key switch. To avoid this battery wear, set the POWER SELECT switch located on the bottom of the unit to the B position, then press the reset button. [. . . ] Be sure to check the power connection diagram sheet supplied with the unit. Improper connections may damage your car. [. . . ]