User manual SONY XR-C7220R

[. . . ] Thank you for purchasing this Sony Cassette Player. This unit lets you enjoy a variety of features as well as a supplied rotary commander or an optional wireless remote. In addition to the cassette playback and radio operations, you can expand your system by connecting an optional CD/MD unit*1. When you connect an optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play a CD TEXT disc*2. [. . . ] Press (SOUND) for two seconds while pushing the VOL control. Tip You can also change the operative direction of these controls with the unit (See "Changing the sound and display settings" on page 21). Tip The unit decreases the volume automatically when a telephone call comes in (Telephone ATT function). The following items can be set: · -- Select "Auto" to dim the display only when you turn the interior lights on. Contrast ­ to adjust the contrast if the indications in the display are not recognizable because of the unit`s installed position. -- Select "Voice 2" to choose a louder volume than "Voice 1. Beep ­ to turn the beep sounds on or off. -- Select "norm" to use the rotary commander in the factory-set position. -- Select "rev" when you mount the rotary commander on the right hand side of the steering column. Loud (Loudness)* 1 ­ to enjoy bass and treble even at low volumes. Each time you press (3) (SET UP), the item changes as follows: Scrl*1 *1 When the radio is off, or when no tape, CD, or MD is playing, this item will not appear. *2 When the optional equalizer preamplifier is not connected, this item will not appear. For the "Contrast" setting, pressing (5) (nmakes the contrast higher, and ) pressing (2) (N makes the contrast lower. After the mode setting is complete, the display returns to normal playback mode. To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency, the subwoofer(s) will output only low frequency signals so you can get a clearer sound image. Press (SHIFT), then press (3) (SET UP) repeatedly until "LPF off" appears. Changing the line output level (XR-C8220R only) You can change the line output level if you hear distortion or other noise. When the optional equalizer preamplifier is connected, you can set this function. Each time you press (5) (nor (2) (N ) ), the cut-off frequency in the display changes as follows: Press (SHIFT), then press (3) (SET UP) until "L. When the frequency setting is complete, the display returns to the normal playback mode. This unit can also control an optional equalizer preamplifier. [. . . ] The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connections and operating procedures. Indications do not appear in the Remove the front panel and clean the connectors. There is noise in the space between tracks. [. . . ]