User manual SONY XR-C7500R

[. . . ] Thank you for purchasing this Sony Cassette Player. This unit lets you enjoy a variety of features using the following controller accessory: Supplied accessory Rotary commander RM-X4S Optional accessory Card remote commander RM-X91 In addition to the cassette playback and radio operations, you can expand your system by connecting an optional CD/MD unit*1. When you operate this unit or a connected optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play a CD TEXT disc*2. *1 You can connect a CD changer, an MD changer, a CD player, or an MD player. [. . . ] If you activate the BTM function while listening to a preset service, the unit will store detected services (by overwriting) only to preset numbers higher than that of the current present service. If you activate the function while listening to a service that is not preset, the unit will replace the contents of all preset numbers. In both cases above, if the unit detects a service that is identical to one already preset, the previously stored service remains unchanged and the newly detected service is not preset. Press number buttons ((1) to (6)) on which the desired service is stored. Press either side of (PRST/DISC) repeatedly until "BTM" appears. After activating the BTM function, the unit tunes the service assigned in the preset memory 1 automatically. Note If the unit can only tune in a few services, the BTM function may not assign services to all the preset service numbers. You can also preset DAB services manually or delete a service which is already preset. Note that up to 40 services (preset either by the BTM function or manually) can be preset to the unit's memory. Press either side of (PRST/DISC) to select "Over Wrt" in step 4, then press (ENTER). Press either side of (PRST/DISC) to select "Insert" in step 4, then press (ENTER). Press either side of (PRST/DISC) repeatedly until "PresetEdit" appears, then press (ENTER). Press either side of (PRST/DISC) to select "Delete" in step 4, then press (ENTER). tip There is another way to preset the service. After receiving the service, press the number button ((1) to (6)) until a beep sounds. " Each time you press (­) side of (PRST/DISC), the edit command changes as follows: Over Wrt t Insert* t Delete t Over Wrt * "Insert" does not appear if the maximum number of services (40) is already preset in memory. To preset other services, repeat steps 3 and 4. Follow the procedure below to tune in a DAB programme manually. You can also store DAB services in the unit's memory for instant tuning (see "Presetting DAB services automatically" on page 20). When you press (LIST) once, the list selected last time appears. Each time you press (LIST), the list changes as follows: While listening to a DAB programme, press (LIST) repeatedly until the Ensemble List appears. Press either side of (PRST/DISC) until the desired ensemble appears, then press (ENTER). [. . . ] Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. Outputs Audio output Power aerial relay control lead Power amplifier control lead Telephone ATT control lead 12 V DC car battery (negative earth) Approx. 2 kg Parts for installation and connections (1 set) Front panel case (1) Rotary commander RM-X4S Card remote commander RM-X91 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer (10 discs) CDX-828, CDX-737 MD changer (6 discs) MDX-65 Other CD/MD units with the Sony-BUS system Source selector XA-C30 DAB tuner unit XT-100DAB Speaker outputs (sure seal connectors) Speaker impedance 4 ­ 8 ohms Maximum power output 50 W × 4 (at 4 ohms) Outputs Design and specifications are subject to change without notice. The following checklist will help you remedy the problems you may encounter with your unit. [. . . ]