User manual SONY XR-C800W

[. . . ] The numbers in the list are keyed to those in the instructions. After installing the steering wheel column cover, attach the rotary remote to the mounting hardware by aligning the four holes on the bottom of the rotary remote to the four catches on the mounting hardware and sliding the rotary remote until it locks into place as illustrated. Note If you are mounting the rotary remote to the steering wheel column, make sure that the protruding tips of the screws on the inner surface of the column do not in anyway hinder or interfere with the movement of the rotating shaft, operative parts of the switches or the electrical cables etc. [. . . ] Bracket Soporte ### Existing parts supplied to your car Piezas existentes suministradas con su automóvil ### Note To prevent malfunction, install only with the supplied screws 4 and use existing parts supplied to your car. Bracket Soporte ### Existing parts supplied to your car Piezas existentes suministradas con su automóvil ### This unit is designed for negative earth 12 V DC operation only. Before making connections, disconnect the earth terminal of the car battery to avoid short circuits. Connect the yellow and red power input leads only after all other leads have been connected. Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position. Run all earth wires to a common earth point. If your car has no accessory position on the ignition key switch -- POWER SELECT switch The illumination on the front panel is factory-set to be turned on even when the unit is not being played. However, this setting may cause some car battery wear if your car has no accessory position on the ignition key switch. To avoid this battery wear, set the POWER SELECT switch located on the bottom of the unit to the B position, then press the reset button. The illumination is reset to stay off while the unit is not being played. Note The caution alarm for the front panel is not activated when the POWER SELECT switch is set to the B position. If the frequency allocation system of your country is based on 10 kHz (200 kHz) interval, set the switch on the bottom of the unit to the 10 K (200 K) position before making connections. With the LINE-OUT/IN SELECT switch on the bottom of the unit, you can change the SUB VOLUME OUT/LINE OUT terminal to work as SUB VOLUME OUT or as LINE OUT terminal. When you want to use the SUB VOLUME OUT/LINE OUT terminal as SUB VOLUME OUT terminal and connect an active subwoofer to it, set the switch to 1. [. . . ] A power aerial without relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. [. . . ]