User manual SONY XR-C8100

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. [. . . ] -- Select "Auto" to dim the display only when you turn the lights on. Contrast to adjust the contrast if the indications in the display are not recognizable because of the unit's installed position. â· Beep to turn on or off the beeps. -- Select "norm" to use the rotary remote in the factory preset position. Loud (Loudness) to enjoy bass and treble even at low volume. Disc MEMO/TEXT name (Disc memo/CDTEXT name) to set the priority display item when you connect an optional CD changer with the CD-TEXT and disc memo function. When the mode setting is complete, the normal playback mode appears. To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency, the subwoofer(s) will output only low frequency signals so you can get a clearer sound image. Press (SHIFT), then press (2) (SET UP) repeatedlly until "LPF" appears. Each time you press (4) (n) or (1) (N), the cut-off frequency in the display changes as follows: When the frequency setting is complete, the display goes back to the normal playback mode. To go back to the normal playback mode, select "Shuf off" in step 2 above. To go back to the normal playback mode, select "Intro off" in step 2 above. -- Program Memory (CD/MD changer with program memory function) You can play tracks in the order you want by making your own program. You can make two programs: Program 1 and Program 2. You can select up to 12 tracks for each program. â· Repeat 2 to repeat a disc. â· Repeat 3 to repeat all the discs in the current changer when you connect two or more changers. Press (SHIFT), then press (3) (PLAY MODE) for two seconds. During playback, press (SHIFT), then press (6) (REP) repeatedly until "Repeat" appears. 3 Press (SHIFT), then press the number button to select the disc. To go back to the normal playback mode, select "Repeat off" in step 2 above. [. . . ] The use of cassettes longer than 90 minutes is not recommended except for long continuous play. The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. Back of the front panel Press the clip inside the front cover with a thin screwdriver, and lever the front cover free. [. . . ]