User manual SONY XR-C8100R

[. . . ] This unit lets you enjoy a variety of features by using either a supplied rotary commander or a wireless remote. In addition to the Cassette playback and radio operations, you can expand your system by connecting an optional CD/MD unit*1. If you operate this unit or connect an optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play back a CD TEXT disc*2. Voice guide for safe driving EN This unit has a voice guide function*. [. . . ] -- Select "Auto" to dim the display only when you turn the lights on. Contrast to adjust the contrast if the indications in the display are not recognizable because of the unit`s installed position. -- Select "norm" to use the rotary commander as the factory-set position. -- Select "rev" when you mount the rotary commander on the right side of the steering column. Loud (Loudness) to enjoy bass and treble even at low volume. Adjust within three seconds after selecting the item. Tip The unit decreases the volume automatically when a telephone call comes in (Telephone ATT function). Each time you press (3) (SET UP), the item changes as follows: Scrl* * When the radio is off, or when there is no tape, CD, or MD being played, these items will not appears Note The displayed item will differ depending on the source. For the "Contrast" setting, pressing (5) (n makes the contrast higher, and ) pressing (2) (N makes the contrast lower. After the mode setting is complete, the display goes back to normal playback mode. You can control up to 7 CD and MD units with this unit. If you connect an optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play back a CD TEXT disc. To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency, the subwoofer(s) will output only low frequency signals so you can get a clearer sound image. Press (MODE) until the desired unit appears. Press (SHIFT), then press (3) (SET UP) repeatedly until "LPF" appears. When a CD/MD unit is connected, all the tracks play from the beginning. Each time you press (DSPL) during CD, CD TEXT or MD playback, the item changes as follows: Each time you press (5) (n or (2) (N ) ), the cut-off frequency in the display changes as follows: When the frequency setting is complete, the display goes back to the normal playback mode. *1 If you have not labeled the disc or there is no disc name prerecorded on the MD, "NO D. *2 If you play a CD TEXT disc, the artist name appears in the display after the disc name. (Only for CD TEXT discs with the artist name. ) *3 If the track name of a CD TEXT disc or MD is not prerecorded, "NO T. [. . . ] Outputs Line outputs (3) Power antenna relay control lead Power amplifier control lead Telephone ATT control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 5 kg Rotary commander (1) Parts for installation and connections (1 set) Front panel case (1) Wireless remote RM-X47 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer CDX-805 (10 discs), CDX-715 (10 discs), CDX-T65 (6 discs), CDX-T62 (6 discs) MD changer MDX-62 Source selector XA-C30 Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 ­ 8 ohms Maximum power output 45 W × 4 (at 4 ohms) Design and specifications are subject to change without notice. The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. [. . . ]