User manual SONY XR-CA320X

[. . . ] Press the (RELEASE) to detach the front panel then gently pull it out. Align parts A and B, and push the front panel in until it clicks. Bend these claws for a tight fit, if necessary. [. . . ] If there is alternator noise (a whining sound when raising engine speed), ground the master unit by connecting it to a metal point of the car with the supplied chassis ground cord 5. Connect the ground cord to the master unit with part 2 as shown in the illustration. Note If you connect an optional power amplifier to the LINE OUT and do not use the built-in amplifier, the beep-tone will be disabled. Handle the bracket carefully to avoid injuring your fingers. The release key 4 is used for dismounting the unit. This unit is designed for negative ground 12 V DC operation only. Connect the unit to the power supply of the car after all other connections are complete. Run all ground wires to a common ground point. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Therefore, be sure to connect passive speakers to these terminals. Power connectors may vary depending on the car. Check your car's power connector diagram to make sure the connections match correctly. You may need to switch the positions of the jump connector. Before connecting the unit to the car`s power supply, be sure to match the position of the jump connector to the car`s pin order. [. . . ] Before connecting the unit to the car`s power supply, be sure to match the position of the jump connector to the car`s pin order. If the power connector of your car does not match the connector on the unit, use the supplied connector 7. If you have any questions or problems connecting your unit that are not covered in this manual, please consult the car dealer. [. . . ]