User manual SONY XR-CA360X

[. . . ] Run all earth wires to a common earth point. Be sure to insulate any loose unconnected wires with electrical tape for safety. When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. [. . . ] When no car circuits are rated high enough, connect the unit directly to the battery. Power connectors may vary depending on the car. Check your car's power connector diagram to make sure the connections match correctly. You may need to switch the positions of the jump connector. Before connecting the unit to the car's power supply, be sure to match the position of the jump connector to the car's pin order. If the power connector of your car does not match the connector on the unit, use the connector 9. If you have any questions or problems connecting your unit that are not covered in this manual, please consult the car dealer. Front speaker Frontlautsprecher Haut-parleur avant Diffusore anteriore Voorluidspreker Rear speaker Hecklautsprecher Haut-parleur arrière Diffusore posteriore Achterluidspreker Power amplifier Endverstärker Amplificateur de puissance Amplificatore di potenza Eindversterker CD/MD changer CD/MD-Wechsler Changeur de CD/MD Cambia CD/MD CD/MD-wisselaar Rotary commander RM-X4S* Joystick RM-X4S* Satellite de commande RM-X4S* Telecomando a rotazione RM-X4S* Bedieningssatelliet RM-X4S* * XR-CA440 only nur XR-CA440 modèles XR-CA440 uniquement solo XR-CA440 alleen XR-CA440 Check the pin position of the power connector of the car with the table in connection diagram (3). Do not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker. Do not connect the earth lead of this unit to the negative (­) terminal of the speaker. To avoid a malfunction, do not use the built-in speaker wires installed in your car if the unit shares a common negative (­) lead for the right and left speakers. Do not connect the unit's speaker cords to each other. Bend these claws outward for a tight fit, if necessary. Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. [. . . ] Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel (4) Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF). [. . . ]