User manual SONY XR-F5100EE

[. . . ] ⷠConnect the power connecting lead 7 to the unit and speakers before connecting it to the auxiliary power connector. ⷠRun all earth leads to a common earth point. ⷠBe sure to insulate any loose unconnected leads with electrical tape for safety. [. . . ] First connect the car aerial to the supplied adaptor, then connect it to the aerial jack of the master unit. *4 Insert with the cord upwards 5 * Supplied with the CD/MD changer *1 , ISO ( ), 5. From the car's power connector 4 5 Yellow Blue continuous power supply epepa aa power aerial control 7 8 Red Black Switched power supply earth Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. ⷠUse speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities to avoid its damage. ⷠDo not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker. ⷠDo not connect the earth lead of this unit to the negative (­) terminal of the speaker. To avoid a malfunction, do not use the built-in speaker leads installed in your car if the unit shares a common negative (­) lead for the right and left speakers. ⷠDo not connect the unit's speaker leads to each other. note on connection If speaker and amplifier are not connected correctly , "FAILURE" appears in the display. In this case, make sure the speaker and amplifier are connected correctly. Existing parts supplied with your car ea, xe e a Existing parts supplied with your car ea, xe e a Choose the installation location carefully so that the unit will not interfere with normal driving operations. ⷠAvoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. ⷠUse only the supplied mounting hardware for a safe and secure installation. [. . . ] Press (OPEN), then slide the front panel to the right side, and pull out the left side. Place the hole A in the front panel onto the spindle B on the unit as illustrated, then push the left side in. 4 Yellow switched power supply 7 Red continuous power supply epepa aa Warning when installing in a car without ACC (accessory) position on the ignition key switch After turning off the ignition, be sure to press and hold (OFF) on the unit until the display disappears. [. . . ]