User manual SONY XR-150

[. . . ] â· When a preset number is indicated in the display , the unit starts storing stations from the one currently displayed. To resume playback, press the other fastwinding button partially until the locked button is released. You can store up to 6 stations on each band (18 for FM1, FM2 and FM3, 12 for AM1 and AM2) in order of your choice. Press the number button ((1) to (6)) momentarily where the desired station is stored. [. . . ] Press either side of (SEEK/MANU) to tune in the station that you want to store on the number button. Keep the desired number button ((1) to (6)) pressed for two seconds until you hear a beep tones. SCAN) momentarily to receive in order the stations stored in the memory (Memory scan Function). Press either side of (SEEK/MANU) momentarily to search for the station (automatic tuning). Scanning stops when the unit receives a station. Press either side of (SEEK/MANU) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (SENS) momentarily until "LCL" (local seek mode) appears in the display. Only the stations with relatively strong signals will be tuned on. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/MANU) until the desired frequency appears (manual tuning). Note If you try to store another station on the same number button, the previously stored station will be erased. When replacing the fuse, be sure to use one matching the amperage rating stated on the fuse. if the fuse blows , check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. in such a case , consult your nearest Sony dealer. Remove the bracket first, then replace the fuse on the rear of the unit. Distorted cassettes and loose labels can cause problems when inserting or ejecting tapes. Other Functions/Additional Information Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Cassettes longer than 90 minutes The use of cassettes longer than 90 minutes is not recommended except for long continuous play. The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. [. . . ] The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. To prevent the unit from being stolen When you leave your car, remove the unit from the bracket and take it away with you. Be sure to turn off the power of the unit before removing the unit, otherwise you may hear a noise. [. . . ]