User manual SONY XR-2500

[. . . ] Up to 6 stations on each band (FM1, FM2, FM3, MW and LW) can be stored on the preset number buttons in the order of your choice. Therefore, 18 FM stations can be Memorised. If you try to store another station on the same preset number button, the most recently stored station will be erased. Press (SEEK/AMS) to search for the station you wish to store on a preset number button. [. . . ] Press the preset number button momentarily ((1) to (6)) on which the desired station is stored. The unit will not store stations with weak signals on the preset number buttons. If there are only a few stations received, some preset number buttons will remain empty. ⷠWhen a preset number indicated on the display, the unit starts storing station from the one currently display. Press either side of (SEEK/AMS) momentarily to search for the station (automatic tuning). scanning stops when a station is received. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (LCL) to light up "LCL" on the display (local seek mode). Only the stations with relatively strong signals are tuned in. Tip If you know the frequency, press and hold either side of (SEEK/AMS) until the desired station is received (manual tuning). Adjust within three seconds after selecting. Never use a fuse whose amperage rating exceeds the one supplied to the unit as this could cause a malfunction of the unit. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Distorted cassettes and loose labels can cause problems when inserting or ejecting tapes. Cassettes longer than 90 minutes The use of cassettes longer than 90 minutes is not recommended except for long continuous play. The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. To prevent the unit from being stolen When you leave your car, remove the unit from the bracket and take it away with you. Caution Be careful when you remove the unit. The rear of the unit becomes very hot just after operating it because of a built-in power amplifer. You can control this unit with the optional rotary commander (RM-X4S). Some labels are supplied with the rotary commander. [. . . ] Attach that label which matches the functions of the master unit and the mounting position of the rotary commander. When you mount the rotary commander, attach the appropriate label, as in the illustration below. 1 SEEK/AMS button 3, 4, 5, 6 2 SOURCE button (TAPE/TUNER) 3, 5 3 (+)(­) (volume/bass/treble/left-right/ front-rear control) button 6 4 MODE (*) button During tuner reception: BAND select 5 During tape playback: Transport direction change 3 5 OFF button 3 6 6 (eject) button 3 7 During radio reception: Preset number buttons 5 During tape playback: (1) INTRO button 4 (2) REPEAT button 4 (4) METAL button 4 (5) ATA (Automatic Tuner Activation) button 4 (6) BL SKIP (Blank Skip) button 4 8 Reset button 3 Press this button when you use this unit for the first time, when you have changed the car battery, or when the buttons of this unit do not function properly. Design and specifications are subject to change without notice. [. . . ]