User manual SONY XR-3200

[. . . ] Before operating the unit for the first time or after replacing the car battery, you must reset the unit. Attach part A of the front panel to part B of the unit as illustrated and push until it clicks. The front panel of this unit can be detached to prevent the unit from being stolen. Make sure the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. [. . . ] When there is a preset number indicated on the display, the unit will store stations on all preset number buttons from the one currently displayed. Tip Press either side of (PRESET/DISC) to receive in order the stations stored in the memory (Preset Search Function) (XR-C353 only). Each time you press (DSPL), the display changes between the frequency and the clock. Press either side of (SEEK/AMS) momentarily to search for the station (automatic tuning). scanning stops when a station is received. Press either side of the button repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (LCL) momentarily to lights up "LCL" on the display (local seek mode). Only the stations with relatively strong signals can be tuned in. Tip If you know the frequency, press and hold either side of (SEEK/AMS) until the desired station is received (manual tuning). Every time you press (SOURCE), the source changes as follows: TAPE n TUNER n CD/MD (XR-C353 only) Pressing (MODE) changes the operation in the following ways: · (XR-C353 only) Tip You can turn on this unit by pressing (SOURCE) on the rotary remote. To playback, rotate and hold the control again, and release it. The first 10 seconds of all the tracks on the current disc are played in order. After the first disc is over, the next disc is played. When you find the desired track, press again . To play all the tracks in the current changer in a random order Press (3) repeatedly during CD/MD playback until "SHUF 2" is displayed. Each time you press (3) the display changes as follows: $ SHUF 1 (Disc shuffle) $ SHUF 2 (Changer shuffle) -- Repeat play To repeat a track Press (2) repeatedly during CD/MD playback until "REP 1" is displayed. If you press (1) during shuffle play, the first 10 seconds of all tracks will be played in random order. Press (2) repeatedly during CD/MD playback until "REP 2" is displayed. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. If no sound comes from the speakers of a 2-speaker system, set the fader control to the centre position. [. . . ] The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism. When replacing the fuse, be sure to use one matching the amperage rating stated on the fuse. if the fuse blows , check the power connection and replace the fuse. [. . . ]