User manual SONY XR-5507

[. . . ] Make sure the front panel is right side up when attaching it to the unit as it cannot be attached upside down. â· Do not press the front panel too hard when attaching it to the unit. It can easily be attached by pressing it lightly against the unit. â· When you carry the front panel with you, keep it in the supplied case. [. . . ] When you tune in an FM station that transmits RDS data, the station name lights up on the display. Note The "*" indication means that an RDS station is being received. Each time you press (DSPL), the displayed items change as follows: Note "NO NAME" lights up if the station received does not transmit RDS data. By using this function, you can continuously listen to the same programme during a longdistance drive without having to re-tune the station manually. The "REG" (regional on) function of this unit lets you stay tuned to a regional programme without being switched to another regional station. (Note that you must turn the AF function on. ) The unit is factory preset to "REG" but if you want to turn off the function, do the following. Press (AF/TA) for more than two seconds until "REG" disappears. Note that turning the "REG" function off might cause the unit to switch to another regional station within the same network. Note This function does not work in the United Kingdom and in some other areas. The Local Link function lets you select other local stations in the area, even though they are not stored in your presets. Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Note that turning the "AF TA" function off stores RDS stations as well as non-RDS FM stations. You can preset the volume level of the traffic announcements beforehand, so you will not miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. Presetting different settings for each preset station Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Press the desired preset number button for two seconds until "MEM" appears. Repeat from step 1 for presetting other stations. If an emergency announcement comes in while you are listening to the radio, the programme will be automatically switched to the announcement. If you are listening to a source other than the radio, the emergency announcements will only be heard if you set AF or TA to on. The unit will then automatically switch to these announcements no matter what you are listening to at the time. Tip If you want to change the preset AF and/or TA setting after you tuned in the preset station, you can do so by turning on/off the AF or TA function. [. . . ] If everything is in order, check the fuse. â· If no sound comes from the speakers of a 2-speaker system, set the fader control to the center position. â· When the tape is played back for a long period, the cassette may become warm because of the built-in power amplifier. However, this is not a sign of malfunction. [. . . ]