User manual SONY XR-6080

[. . . ] Before operating the unit for the first time or after replacing the car battery, you must reset the unit. Attach part A of the front panel to part B of the unit as illustrated and push until it clicks. The front panel of this unit can be detached in order to prevent the unit from being stolen. Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. [. . . ] Your car stereo offers you a variety of services. Depending on the country or region, not all of the RDS functions are available. â· RDS may not work properly if the signal strength is weak or if the station you are tuned in is not transmitting RDS data. By using this function, you can continuously listen to the same programme during a longdistance drive without having to re-tune the station manually. When you tune in an FM station that transmits RDS data, the station name lights up on the display. Press (AF/TA) until "AF" lights up on the display. The unit starts searching for an alternative station with a stronger signal in the same network. Note When there is no alternative station in the area, and you don't need to search for an alternative station, turn the AF function off by pressing (AF/TA) until "AF TA" disappears. Each time you press (AF/TA), the displayed items change as follows: z AF z TA z Blank Z AF TA* Note The "*" indication means that an RDS station is being received. Each time you press (DSPL), the displayed item changes as follows: * Select this to turn on both AF and TA functions. If the station service name starts flashing after you've made the preset selection, it means that no alternative frequency is available and the unit cannot receive the PI (Programme Identification) data of the memorized station. "TP" lights up on the display when the unit finds a station broadcasting traffic announcements. When the traffic announcement starts, "TA" flashes, then flashing stops when the traffic announcement is over. If an emergency announcement comes in while you are listening to the radio, the programme will be automatically switched to the announcement. If you are listening to a source other than the radio, the emergency announcements will only be heard if you set AF or TA to on. The unit will then automatically switch to these announcements no matter what you are listening to at the time. When you preset the RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. You can locate the station you want by selecting one of the programme type shown below. Note In the countries or regions where EON data is not transmitted, you can use this function only for the stations you have tuned in once. Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Note that turning the "AF TA" function off stores RDS stations as well as non-RDS FM stations. [. . . ] Each time you press (DSPL) momentarily during CD playback, the displayed item changes as follows: -- Repeat play To repeat a track Press (2) repeatedly during CD playback until "REP 1" is displayed. During playback, press either side of (SEEK/AMS) the number of times you wish to skip the tracks. Press (2) repeatedly during CD playback until "REP 2" is displayed. During playback, press and hold either side of (SEEK/AMS). [. . . ]