User manual SONY XR-6387

[. . . ] If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. If no sound comes from the speakers of a 2-speaker system, set the fader control to the center position. If your car is equipped with a power antenna, note that it will be automatically extended while the unit is operating. [. . . ] When an FM stereo program with a sufficient signal strength is tuned in, Release the button when the desired station is received. When tuning in during driving, use the automatic tuning and the memory preset tuning instead of the manual tuning. Tune in the station which you wish to store on the preset number button. Press and hold the desired preset number button ( 1 to 6 ) for about two seconds until you hear a beep tone. This function selects from the currently received band the stations with the strongest signals and memorizes them in order of their frequency. The number of the pressed preset number button appears in the display window. Up to 6 stations on each band (FM1, FM2 and FM3) can be stored on the preset number buttons in the order of your choice. Therefore, 18 stations can be memorized on FM. If you try to store another station on the same preset number button, the previously stored station will be erased. Press the PTY button for more than two seconds. When there is no preset number indicated on the display window, stations will be stored on all preset number buttons on the currently selected band. Press the AF/TA button for more than two seconds until "REG OFF" lights up in the display. Note that selecting "REG OFF" might cause the unit to switch to another regional station within the same network. Note This function does not work in the United Kingdom and in some other areas. Tip When the traffic announcement starts while you are listening to another programme source, the unit automatically switches to the announcement and goes back to the original source when the announcement is over. notes · "NO TP" flashes for five seconds if the received station doesn't broadcast traffic announcements. Then, the unit starts searching for a station that does broadcast traffic announcements. When the "EON" indication appears with "TP" in the display window, the current station makes use of broadcast traffic announcements of other stations in the same network. To cancel all traffic announcements, turn off the function by pressing the AF/TA button until "AF/TA OFF" lights up. The Local Link function lets you select other local stations in the area, even though they are not stored in your presets. You can preset the volume level of the traffic announcements beforehand so you wouldn't miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. [. . . ] Repeat from step 1 for presetting other stations. Note You cannot use this function in some countries where no PTY (Programme Type selection) data is available. Press the PTY button during FM reception until "PTY" lights up in the display. "- - - - -" appears if the received station is not an RDS station or if the RDS data has not been received. [. . . ]