User manual SONY XR-C210

[. . . ] They are used for tuner adjustments to be made only by service technicians. If you mount other Sony equipment with this unit, it is better to mount this unit in the lower position. There must be a distance of at least 15 cm between the cassette slot of the unit and shift lever in order to insert a cassette easily. Choose the installation location carefully so the unit does not interfere with gear shifting and other driving operations. [. . . ] Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF). Press (OPEN), then slide the front panel to the right side, and pull out the left side. Place the hole a in the front panel onto the spindle b on the unit as illustrated, then push the left side in. Bend these claws outward for a tight fit, if necessary. First attach 5 to the unit, then insert the unit into 1. When the installation and connections are complete, be sure to press the reset button with a ballpoint pen, etc. The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the ATA (Automatic Tuner Activation), AF (Alternative Frequency) or the TA (Traffic Announcement) function. A power aerial without a relay box cannot be used with this unit. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 7 may damage the aerial. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Be sure to connect passive speakers to these terminals. [. . . ] Doing so may damage the active speakers. Be sure to connect passive speakers to these terminals. Note for the aerial connecting If your car aerial is an ISO (International Organization for Standardization) type, use the supplied adapter 6 to connect it. First connect the car aerial to the supplied adapter, then connect it to the aerial jack of the master unit. [. . . ]