User manual SONY XR-C5120

[. . . ] 3-865-814-11(1) FM/AM Cassette Car Stereo Operating Instructions US Owner's Record The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. XR-C5120/4890 Serial No. For installation and connections, see the supplied installation/connections manual. XR-C5120 XR-4890 © 1999 by Sony Corporation Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Press (MODE) repeatedly to select the band. To start playback while fast-winding the tape, press (MODE). ·Locate a specific track on a disc. Rotate and hold the control until you locate the specific point in a track, then release it to start playback (XR-C5120 only). Rotate and hold the control to find a specific station. The operative direction of controls is factoryset as shown below. To increase To decrease By pushing in and rotating the control (the PRESET/DISC control) If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction. Push in and rotate the control to: ·Receive the stations memorized on the number buttons. ·Change the disc (XR-C5120 only). Press (SOUND) for two seconds while pushing the VOL control. Tip You can also change the operative direction of these controls with the unit (page 12). Other operations Rotate the VOL control to adjust the volume. Press (ATT) to attenuate the sound. OFF Press (OFF) to turn off the unit. 11 Adjusting the sound characteristics You can adjust the bass, treble, balance, and fader. You can store the bass and treble levels independently for each source. Changing the sound and display settings The following items can be set: ·CLOCK (page 6). ·BEEP ­ to turn the beep sound on or off. ·RM (Rotary Commander) ­ to change the operative direction of the rotary commander. -- Select "NORM" to use the rotary commander as the factory-set position. -- Select "REV" when you mount the rotary commander on the right side of the steering column. ·M. DSPL ­ to turn the Motion Display on or off. ·A. SCRL (Auto Scroll)* (page 14). 1 Select the item you want to adjust by pressing (SOUND) repeatedly. VOL (volume) n BAS (bass) n TRE (treble) n BAL (left-right) n FAD (front-rear) 2 Adjust the selected item by rotating the dial. Adjust within three seconds after selecting the item. (After three seconds, the dial function reverts to volume control. ) 1 2 Press (SHIFT). Press (2) (SET UP) repeatedly until the desired item appears. Each time you press (2) (SET UP), the item changes as follows: CLOCK nBEEP nRM nM. DSPL nA. SCRL* * When no MD is playing, this item will not appear (XR-C5120 only). Note The displayed item will differ depending on the source. Attenuating the sound Press (ATT) on the optional rotary commander or wireless remote. To restore the previous volume level, press (ATT) again. 3 4 Press (4) (n) to select the desired setting (Example: ON or OFF). [. . . ] n Store again into the memory. The contents of the memory have been erased. Indications do not appear in the Remove the front panel and clean the connectors. "Cleaning the connectors" (page 17) for details. Tape playback Problem The sound is distorted. Cause/Solution The tape head is contaminated. n Clean the head with a commercially available dry-type cleaning cassette. [. . . ]