User manual SONY XR-C610

[. . . ] Choose the exact location for the rotary commander to be mounted, then clean the mounting surface. Dirt or oil impair the adhesive strength of the double-sided adhesive tape. The numbers in the list are keyed to those in the instructions. Use the screw holes on the mounting hardware 0 to mark the positions. [. . . ] On the other side of the mounting surface to cover the protruding tips of the screws so that they will not interfere with the electrical cables, etc. Handle the bracket carefully to avoid injuring your fingers. When the installation and connections are complete, be sure to press the reset button with a ballpoint pen, etc. The following check will assist in the correction of most problems which you may encounter with your unit. Before going through the check list below, refer to the connection and operating procedures. problem · Memorised stations and correct time are erased. Makes noise when the ignition key is the ON, ACC and OFF positions. No power is being supplied to the unit. Cause Leads are not matched correctly with the car's accessory power connector. After installing the steering wheel column cover, attach the rotary commander to the mounting hardware by aligning the four holes on the bottom of the rotary commander to the four catches on the mounting hardware and sliding the rotary commander until it locks into place as illustrated. Note If you are mounting the rotary commander to the steering wheel column, make sure that the protruding tips of the screws on the inner surface of the column do not in anyway hinder or interfere with the movement of the rotating shaft, operative parts of the switches or the electrical cables, etc. If the supplied power connecting cord can not be used with your car, consult your nearest Sony dealer. The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the ATA (Automatic Tuner Activation), AF (Alternative Frequency) or the TA (Traffic Announcement) function. A power aerial without a relay box cannot be used with this unit. When your car has a built-in FM/MW/LW aerial in the rear/side glass, it is necessary to connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 8 may damage the aerial. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. [. . . ] Continuous power supply suministro de alimentación continua kontinuerlig strömförsörjning alimentação de corrente contínua power aerial control control de antena motorizada styrning av motorantenn antena eléctrica switched illumination power supply fuente de alimentación de iluminación conmutada Switchad strömförsörjning till belysning fonte de alimentação comutada para iluminação Switched power supply suministro conmutado de alimentación switchad strömförsörjning alimentação de corrente comutada earth toma de tierra jord Terra After connecting, bundle up the connecting cord of the rotary commander with other connecting cords of the audio equipment by attaching the supplied cramper qa. Be sure to leave some slack in the connecting cord between the plug and the cramper as illustrated. När du är klar fäster du ihop sladden till vridkontrollen och andra sladdar till ljudutrustningen med medföljande krampa qa. Qa Auxiliary power connector may vary depending on the car. [. . . ]