User manual SONY XR-C9100

[. . . ] The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] ⷠWhen the disc magazine contains no tracks stored into the program memory, or when the program information has not been loaded yet, "Not ready" appears. Press (SHIFT), then press (4)(PLAY MODE) for two seconds. Press (SHIFT), then press (4)(PLAY MODE) for two seconds. Press (2)(N) or (5)(n) to select the track slot number where you want to insert a track. Track slot number Push the SEEK/AMS control up or down to select the track you want to insert. press (6)(ENTER) momentarily to enter the track. The current track in that slot number and the succeeding tracks shift down. To continue inserting tracks, repeat steps 2 through 4. Note Once all 12 slots have been filled, "*Mem Full*" appears in the display, and you cannot insert more tracks. When you finish inserting tracks, press (4)(PLAY MODE) for two seconds. When you finish erasing the programs, press (4)(PLAY MODE) for two seconds. Press (SHIFT), then press (4)(PLAY MODE) for two seconds. You can label each disc with a personalized name. You can enter up to eight characters for a disc. If you label a CD, you can locate the disc by name and select the specific tracks for playback (page 23). Play the CD and press (LIST) for two seconds. Track slot number When you erase a track from a slot number, the succeeding tracks shift up to fill the gap. If you want to put a blank space between characters, select "_" (underbar). When you finish erasing tracks, press (4) (PLAY MODE) for two seconds. 3 Repeat steps 1 and 2 to enter the entire name. To return to normal CD playback mode, press (LIST) for two seconds. Tip To erase or correct a name enter "_" (under-bar) for each character. [. . . ] ⷠNever touch the connectors directly with your fingers or with any metal device. POWER OUTPUT AND TOTAL HARMONIC DISTORTION 19 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 1 % total harmonic distortion. Other specifications Cassette player section Outputs Line outputs (2) Subwoofer output Power antenna relay control lead Power amplifier control lead Telephone ATT control lead Illumination control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 5 kg Rotary commander (1) Parts for installation and connections (1 set) Front panel case (1) BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) Wireless remote RM-X47 (1) CD changer CDX-805 (10 discs), CDX-715 (10 discs), CDX-T65 (6 discs), CDX-T62 (6 discs) MD changer MDX-62 Digital preamplifier XDP-210EQ, etc Source selector XA-C30 TV tuner XT-40V, etc Design and specifications are subject to change without notice. [. . . ]