User manual SONY XR-DV526

[. . . ] Playing tracks in random order -- Shuffle Play. Using the rotary commander (XR-CA440 only) . 17 Selecting the sound position -- My Best sound Position (MBP) . L RESET button (located on the front side of the unit, behind the front panel) 6 m AF button 11, 13 n SENS/BTM button Storing the stations with the strongest signals. [. . . ] The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI SEEK" appears). If the unit cannot find the same PI, the unit returns to the previously selected frequency. These settings function regardless of the current FM programme/source, CD/MD; the unit switches back to the original source when the bulletin is over. The unit will continue searching for stations available with TP if "NO TP" is indicated. When AF function is on: this unit's factory-set setting restricts reception to a specific region, so you won't be switched to another regional station with a stronger frequency. If you leave this regional programme's reception area or would like to take advantage of the whole AF function, select "REG-OFF. " During radio reception, press (AF) for two seconds until "REG-OFF" appears. Selecting "REG-OFF" might cause the unit to switch to another regional station within the same network. Note This function does not work in the United Kingdom and in some other areas. Each time you press (AF) for two seconds, the item changes as follows: You can preset the volume level of the traffic announcements so you won't miss hearing them. This function enables you to select other local stations in the area, even if they are not stored on your number buttons. Tip When the interface cable of a car telephone is connected to the ATT lead, the unit decreases the volume automatically when a telephone call comes in (Telephone ATT function). The following items can be set: When you drive without passengers, you can enjoy the most comfortable sound environment with "My Best sound Position. " "My Best sound Position" has two presets, which are best suited for the front seats. You can select one very easily with the MBP button. DSPL (Motion Display) ­ the demonstration mode which appears when the tape is ejected and no source is selected (e. * When no CD or MD is playing, this item will not appear. After 1 second, the display goes back to the normal playback mode. to cancel the MBP function , select "MBP-OFF. " If you want to adjust the sound characteristics more precisely, you can do it using the (SEL) button (see "Adjusting the sound characteristics" on page 16). notes · If you adjust any sound characteristics by using the (SEL) button (page 16), the MBP setting returns to OFF. When MBP is set to OFF, the sound setting you adjusted (page 16) is activated. [. . . ] 2 kg Parts for installation and connections Front panel case (1) Rotary commander RM-X4S* BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer (6 discs) CDX-T70MX, CDX-T69 MD changer (6 discs) MDX-66XLP MG Memory Stick Systemup Player MGS-X1 Source selector XA-C30 Design and specifications are subject to change without notice. The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. There is noise in the space between tracks. [. . . ]