User manual SONY XR-H33MD

[. . . ] aiwa MD/CD STEREO SYSTEM XR-H33MD OPERATING INSTRUCTIONS For assistance and information call toll free 1-800-BUY-AIWA (United States and Puerto Rico) 87-NB8-909-01 971220AKY-U-0 ENGLISH pg. 1 WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. "CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER TO QUALIFIED SERVICE PERSONNEL. " Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's inclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Owner's record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. [. . . ] NOTE · While TOC EDIT is displayed, do not disconnect the AC cord or shake the unit. Otherwise, the TOC data is not registered properly. · During recording with the CD MD button, the button cannot be used. · Nothing other than an MD should be inserted into the disc drive. Otherwise the disc may become scratched, causing a malfunction of safety hazard such as an electric shock. · Do not attempt to insert another MD while and MD is already inside the disc drive. · Do not tilt the unit with a disc inserted. Doing so may cause malfunction. MD RECORDING (cont) AUTO FIRST TRACKS RECORDING OF CDS pg. 20 Only the first track of the CDs on the tray are recorded continuously. You can keep recording continuously without interruption, if you press the DISC CHANGE button to replace the CDs during recording. 1 Insert a recordable MD into the disc drive with the label side up and in the direction of the arrow. 2 Press the CD button and load the CDs to be recorded. 3 Press the CD MD button twice to start recording. "CD MD single" is displayed and recording begins with the first track of the CD on tray 1. To replace CDs during recording, press the DISC CHANGE button and replace with other CDs. Then, press the DISC CHANGE button to close the disc compartment. When recording finishes, TOC EDIT is displayed and the data concerning the contents of the recording are registered. · The index mark is registered automatically at the beginning of the track. Display information during recording When DISP is pressed repeatedly during recording, the display changes as follows. * During "AUTO FIRST TRACKS RECORDING", the remaining time of CD is not displayed. PROGRAMMED RECORDING OF CDS Up to 30 tracks can be programmed and recorded from any of the inserted CDs. 1 Insert a recordable MD into the disc drive with the label side up and in the direction of the arrow. 3 Press PRGM on the remote control while pressing SHIFT. 4 Press the DISC DIRECT PLAY 1-3 to select a CD. Then, press the numbered buttons 0-9 and +10 button to program a track. 5 Repeat step 4 to program other tracks. 6 Press the CD MD button to start recording. When the programmed tracks finish playing, the recording stops automatically. [. . . ] The temperature of the unit is too high. The surrounding temperature is too high or too low. Emergency PB Disc The unit operates abnormally due to a scratched disc or strong shock. There is an attempt to record or edit a prerecorded music disc (optical disc). [. . . ]