User manual SONY XR-U550RDS

[. . . ] Use only the supplied mounting hardware for safe and secure installation. How to detach and attach the front panel Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF) first. Then press (OPEN) to open the front panel, then slide the front panel to the right side, and pull out the left side of the front panel. [. . . ] Place the hole a in the front panel onto the spindle b on the unit as illustrated, then push the left side in. Bend these claws for a tight fit, if necessary. When the installation and connections are are complete, be sure to press the reset button with a ballpoint pen etc. Front speakers Altavoces delanteros Högtalarna framtill Altifalantes dianteiros Rear speakers Altavoces traseros Högtalarna baktill Altifalantes traseiros Active subwoofer Altavoz potenciador de graves activo Aktiv subwoofer Subwoofer activo For connecting two or more changers, the source selector XA-C30 (optional) is necessary. The numbers in the list are keyed to those in the instructions. If there is alternator noise (a whining sound when the engine increases speed), earth the master unit by connecting it to a metal point of the car with the supplied chassis earth cord !Connect the earth cord to the master unit with part 2 as shown in the illustration. You can use part 7 to connect the earth cord to the master unit instead of part 2. Handle the bracket carefully to avoid injuring your fingers. This unit is designed for negative earth 12 V DC operation only. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Therefore, be sure to connect passive speakers to these terminals. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 9 may damage the aerial. Install the inverter far away from the unit using double-side adhesive tape or something similar. * Note for the aerial connecting If your car aerial is an ISO (International Organization for Standardization) type, use the supplied adapter 6 to connect it. [. . . ] Install the inverter far away from the unit using double-side adhesive tape or something similar. * Note for the aerial connecting If your car aerial is an ISO (International Organization for Standardization) type, use the supplied adapter 6 to connect it. First connect the car aerial to the supplied adapter, then connect it to the aerial jack of the master unit. Anslut först motorantennen till medföljande adapter och därefter till antennuttaget på huvudenheten. [. . . ]