User manual SONY XR-U660

[. . . ] Sony has developed a new function which contributes to safer driving. In addition to our unique rotary commander, we now introduce a voice sensitive operating system Voice Drive which gives the driver voice control of the car audio. Now, while keeping your eyes on the road, you can command operations with Voice Drive and confirm results with Voice Guide. And you can also record your voice with the voice memo function. [. . . ] In such a case, erase the older recorded voice memos before recording new ones. Playing back the voice memo Using the rotary commander the rotary commander works by pressing buttons and/or rotating controls. You can control an optional CD or MD unit with the rotary commander. Select the desired voice memo using the SEEK/AMS control. Adjust the volume on the main unit or by using the rotary commander. The unit automatically returns to the previous source after playing back all of the voice memos. Playback stops and the unit automatically returns to the previous source. Each time you press (SOURCE), the source changes as follows: Play back the voice memo to be erased. Press and hold (PLAY) on the rotary commander until a beep sound is heard. Pressing (MODE) changes the operation in the following ways; The voice memo will be erased and the numbers of succeeding voice memos will move up respectively. Tip When the POWER SELECT switch is set to position B, you can turn on this unit by pressing (SOURCE) on the rotary commander. You can control up to 7 CD and MD units with this unit. If you connect an optional CD unit with the CD TEXT function, the CD TEXT information will appear in the display when you play a CD TEXT disc. You can label CD and CD TEXT discs with a personalized name using the disc memo function; refer to "Labeling a CD" (page 29). However, if you use personalized labels, they will always take priority over the original CD TEXT information when such information is displayed. Tip If the name of the MD or CD TEXT disc is too long, you can scroll it across the display by pressing (SHIFT), then (2) (N). Press (MODE) until the desired unit appears. The disc name appears when the disc has changed (if the disc name is selected). The track name appears when the track has changed (if the track name is selected). When a CD/MD unit is connected, all the tracks play from the beginning. If you press (DSPL) to change the display item, the disc or track name of the MD or CD TEXT disc is scrolled automatically whether you set the function on or off. Each time you press (DSPL) during CD, CD TEXT, or MD playback, the item changes as follows: Note For some CD TEXT discs with extremely many characters, the following cases may happen: -- Some of the characters are not displayed -- Auto Scroll does not work. [. . . ] A blank space is too short (less than four seconds). The SEEK/AMS control is pushed up immediately before the following tracks. The SEEK/AMS control is pushed down immediately after the track starts. A long pause, or a passage of low frequencies or very low sound level is treated as a blank space. [. . . ]