User manual SONY XS-GTX121LB DATASHEET

[. . . ] The four feet should be used without the pads on carpet. Disc Feet With Spikes: Each threaded post has one pointed end for use as a carpet spike. This point can pierce thick carpeting and support the speaker from the floor underneath. Note: these spikes will make small but deep punctures in most floors. [. . . ] Use the Disc Feet to avoid this. 2 Disc Feet Installation: 1. Install the pointed end of a threaded post into the end of each arm of the metal stands. Thread a lock nut most of the way up each post. Screw a disc foot onto the end of each post about seven complete turns. Apply the self-adhesive foot pads, if necessary for your floor surface. When the final speaker placement is determined, adjust the position of each disc foot on the threaded post until stable placement has been achieved. Hand twist the lock nut down onto the disc foot to secure. 1. Disc Feet With Spikes Installation: It is difficult to move the speaker once the spikes are installed on the stands. Install the Disc Feet on the speaker first and determine exactly where you want to place the speaker on a carpet, then change the feet to exposed spikes. Install the blunt end of a threaded post into the end of each stand arm. Determine which conductor you will use to connect the positive terminals of the amplifier and speaker together. One of the two conductors of a speaker cable can usually be distinguished by printing or a ridge on the insulation. Some times the metal of the conductors has two different colors. Strip 1/2 inch 5 MAKING THE CONNECTION 1. Unscrew the speaker's red and black connector knobs to expose the holes in their threaded shafts. Insert the stripped end of one cable's "indicated" conductor into the speaker's red (+) connector. Hand-tighten the knob to secure the connection. Make sure no stray strands of wire are exposed. If you are using a cable connector plug, connect it according to its instructions 3. Repeat the procedure for the cable's other conductor and the speaker's black (­) connector. [. . . ] Repeat the procedure for the cable's other conductor and the speaker's black (­) connector. Connect the other speaker cable's conductors to the other speaker. Connect the opposite ends of the speaker cable to the speaker outputs of your receiver. Remember to observe channel and polarity (Left Positive, Left Negative, Right Positive, Right Negative). 6 SPECIFICATIONS Dimensions (H x W x D): 32 1/2 x 7 3/8 x 12 1/2 inches (825 x 186 x 320 mm) Base width: 11 3/16 inches (284mm) Weight: 34 pounds The T100 can be safely used with receivers rated above 20 watts per channel. [. . . ]