User manual SONY XS-L122P5 INSTALLATION/CONNECTIONS

[. . . ] 2 Installation Sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Speaker Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Speaker Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Satellite Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] All the items shown in the illustration should be included. If anything is missing, notify the retailer. Save the carton and its inserts in case you need to transport your PCWorks FourPointSurround system later. Overview PCWorks FourPointSurround consists of a powered subwoofer, four satellite speakers and a volume control. All five speakers are magnetically shielded. The subwoofer is designed to sit on the floor beneath a desk, and sounds best in this position. The satellites used for the front left and right channels should flank the computer monitor. The satellites used for the rear left and right channels can be placed on the desktop, on floor stands, or attached to other sites with hook and loop fasteners. Installation Sequence 1. Read through the instructions before installing the speakers. The instructions assume you have a 4-channel sound card, one that supports DirectSound3D and has front and rear stereo outputs. If your sound card has a single stereo minijack line output, please read the note under "Volume Control" on page 8. Place the satellites and the subwoofer at appropriate sites near your computer. The closer the subwoofer is to the corner, the stronger the maximum bass output. Alternately, it can be placed on a shelf or other sites, but its maximum output will be reduced. A B C D 3 Speaker Wiring Diagram CAMBRIDGE SOUNDWORKS BASS LEVEL FRONT LEFT FRONT REAR AUDIO INPUTS PCWORKS XS-L122P5 TM TM REAR LEFT SONY NEWTON, MASSACHUSETTS USA FRONT LEFT FRONT RIGHT FRONT LEFT REAR LEFT SPEAKERS REAR LEFT REAR RIGHT FRONT RIGHT REAR RIGHT 12V DC IN POWER ON/OFF FRONT RIGHT REAR RIGHT 4 Satellite Connections One pair of satellites has cables 9 feet (3 meters) long; the other pair's cables are 12 feet (4 meters) long. Typically, the satellites in the rear will require longer cable lengths, but the satellites are otherwise identical. If you need extra cable length for the front channel satellites, use the ones with longer cable there instead. Make sure the stand is securely pressed into the slot (see Diagram F). At the base of the rear leg, gently pull on the satellite cable to remove any unnecessary slack in the cable. Insert a rubber plug into the base of each leg, taking care to feed the cable out the short notch in the rear leg (see Diagram G). C D E 6 Power Supply Adapter Confirm that the power switch is in the "OFF" position. Insert the power supply's AC plug into the appropriate receptacle. Insert the small DC connector into the "12V DC IN" receptacle on the back of the subwoofer. G F 7 The Volume Control minijack of your soundcard (see "F" SUB plug to the "Front" miniIf you upgrade to a four-channel The PCWorks FourPointSurround diagram I). Leave the "R" LINE jack input on the subwoofer. Leave sound card, connect both "F" and system comes with a separate plug unconnected. [. . . ] Be sure to apply the stick-on rubber feet to the back of the satellite cubes. This assures an acoustically secure installation. Hook and loop fastener mounting Keyhole slot mounting 11 Specifications PC Works FourPointSurround's Five-channel Amplifier Specifications Satellite amplifier: One channel driven into a 4 ohm load at less than 1% total harmonic distortion, at 1kHz: 3. 5 watts RMS. Subwoofer amplifier: With a 4 ohm load at less than 1% total harmonic distortion, at 100Hz: 10 watts RMS. These specifications apply to a PCWorks FourPointSurround operating from a 120 VAC line and a 12V DC power adapter. Technical Support Inside U. S. A. , Canada and Latin America Creative Labs Inc. [. . . ]