User manual SONY XS-TL1

[. . . ] The numbers in the list are keyed to those instructions. Built-in PWM amplifier with maximum power output of 100 watts · High level input connection to allow connection with audio systems not equipped with a line output Choose the installation location carefully so that the unit does not interfere with driving and/or visibility. Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or heater exhaust, or where it would be subject to dust, dirt or excessive vibration. [. . . ] Connect the yellow power input leads only after all other leads have been connected. Install the RCA pin cords and speaker cords away from the power supply leads as running them close together can generate interference noise. Make sure all other electric devices such as brakelights and headlights are working properly after installation and connection is complete. Be sure to check the turn signals and the horn. Connect the yellow cord to an unused car circuit with an amperage rating higher than required by the system components. If you connect this unit in series with other stereo components, use the sum of the fuse ratings for the individual components to determine the required amperage. If no circuits are available at the required rating, connect the unit directly to the car battery. If you must connect the unit to an occupied circuit, select one that is rated higher than you require and in such a way that if the unit's fuse were to blow, no other circuits would be lost. Note If your car has an on-board computer or navigation system installed, disconnecting the car battery's negative terminal can erase their memories. In such a case, make sure that all the connections except the yellow power input lead are complete before connecting the yellow power input lead. To the +12 V power terminal which is energized at all times vers la borne d'alimentation +12 V qui est alimentée en permanence To a metal point of the car First connect the black ground lead, then connect the yellow power input lead. If you use the HIGH LEVEL INPUT connection, you do not need to connect the remote input cord (Blue/White striped) for the unit to turn on automatically. If the signals are weak, the unit will not turn on automatically. To the +12 V power terminal which is energized at all times Be sure to connect the black ground first. To the remote output terminal of the car audio When using a car audio without a remote output, connect the remote input cord to the accessory power supply. Blue/White striped Rayé bleu/blanc Yellow Jaune Black Noir Note When connecting leads to a power amplifier, remove the plug type connector and strip the wire or replace it with a suitable connector (not supplied). [. . . ] 2 LOWBOOST control Use this control to boost the frequencies around 50 Hz to a maximum of 10 dB (Diagram 1). 5 POWER indicator When the power is turned on, the POWER indicator lights up. When installing an additional power amplifier using the LINE OUTPUT terminal Installation d'un amplificateur de puissance supplémentaire à l'aide de la borne LINE OUTPUT If the fuse blows again after replacement, there may be an internal malfunction. [. . . ]