User manual SONY XT-V70

[. . . ] If the fuse blows again after replacement, there may be an internal malfunction. 1 Using a spray bottle, wet the inside of the front window well with a mild detergent solution. The optimal solution is 500 ml of water with one or two drops of detergent (8-1). (Pure water will not work well for making fine adjustments. [. . . ] ) , the signal reception will be extremely poor. - The aerial cannot be mounted in cars which have airbags in the front pillars. ⷠMount the aerial to the front window, in the specified location and according to the specified dimensions. - The supplied film aerial is designed for attaching only to the front window. If attached to the rear window or elsewhere in the car, the signal reception may be extremely poor. notes · Once you have mounted the film aerial, do not attempt to remove it and attach it again, as the adhesive will be considerably weakened. Be sure to temporarily fasten the cable and aerial in place and check that the cable has sufficient play before permanently attaching. ⷠDuring the mounting procedure, it will be necessary to remove the front pillar molding to attach a ground wire. When performing the installation yourself, if you decide it is too difficult to remove the front pillar molding, please contact your dealer for assistance. (Note that your dealer may charge a fee for their assistance. Have the following items handy before beginning the mounting procedure. Spray bottle (fill with 500 ml water and one or two drops of detergent) · paper towels Note Mount the film aerials to the inside of the front window. Do not mount the aerials anywhere other than the location described here. Before attaching Using the supplied cleaning cloth qa to wipe away any oil, wax, or dust tat may be on the window. Black To the +12 V power terminal which is energized in the accessory position of the ignition key switch. Be sure to connect the black ground lead to it first. 1 Align the film aerial power supply point with the lower edge of the window's ceramic line and fasten temporarily in place with cellophane tape (6-1). Do not remove the adhesive backing from the aerial yet. The figure shows the results of this step, for the left aerial. temporarily position the right aerial in the same manner. 2 Mark the left and right sides of the film aerial, using cellophane tape, etc (6-2). Remove the inner molding from the front pillars on both sides of the front window (7) The figure shows an example of a car, such as a sedan or SUV, which as a handle mounted on the front pillar. [. . . ] Mount the TV aerial amplifier unit 4 (qa) 1 Mount the TV aerial amplifier unit near the floor in the foot area in front of the passenger's seat. (Be sure to wipe away any dirt on the mounting surface. Important note It would be extremely dangerous if the TV aerial amplifier unit were to get stuck underneath the brake pedal. 2 Connect the grounding cable from the TV aerial amplifier unit to a metal part of the car body where it can make a good ground contact. [. . . ]