User manual SONY XT-C100

[. . . ] ) 2 Remove the clear backing from the film aerial. Using the spray bottle, wet the exposed surface well with the mild detergent solution (8-2). ⷠGrasp the peel-off tab and peel the clear backing off slowly. ⷠDo not remove the protective sheet from the other side (the side that faces the inside of the car) yet. [. . . ] Do not install the TV tuner unit ­ in locations subject to high temperatures. ­ in locations subject to direct sunlight, warm air from heater outlets, or other locations that can get hot. ⷠWhen attaching the hook-and-loop fastener to the bottom of the TV tuner unit, do not cover the model name plate in the center. keep the units and connection cables apart. The AV Center main unit, the monitor, TV tuner unit, and RCA interconnects should not be in close proximity. Otherwise noise interference may affect the TV picture. 5 Use paper towels to wipe away the excess detergent solution and dry the aerial well. We recommend you let the aerial dry for 3-4 hours. Do not try to rush the drying process by using a hair dryer or other heater. It may not be possible to mount the aerial on some cars. - In cars with glass that does not transmit radio waves (infrared reflecting glass, insulated glass, glass that is opaque to electromagnetic waves, etc. The molding on the front pillar will be fastened in place with clips or screws. When removing it, take care not to damage or deform it. ⷠWhen performing the installation yourself, if you decide it is too difficult to remove the front pillar molding, please contact your dealer for assistance. (Note that your dealer may charge a fee for their assistance. TV aerial amplifier unit 4 4 4 TV aerial amplifier unit 4 4 4 Fold back the floor mat. Attach the power supply terminal to the film aerial 5 (9) 1 Remove the power supply point protective sheet from the film aerial (9-1). The color of the protective sheet is used to distinguish the left and right aerials. The right aerial (as seen from inside the car) has a blue protective sheet, and the left aerial has a white protective sheet. Take care to mount the aerials on the proper side of the car. 38 kg (13 oz) Design and specifications are subject to change without notice. The same type of cable is used for both the left and right aerials. [. . . ] 3 Route the aerial input cable , using the supplied aerial cord clamp 9 to hold it in place (0-2 , 3 , 4). Route the cable so that it will be completely covered when the front pillar molding is replaced. Important note Use tape or other fasteners to route the cables such that they cannot interfere with vehicle operation. Do not wrap the cables around the steering column, gear shift lever, brake pedal, etc. [. . . ]