User manual SONY XVM-40

[. . . ] ⷠDo not get the wires under a screw, or caught in moving parts (e. Before making connections, turn the car ignition off to avoid short circuits. ⷠConnect the red power input leads only after all other leads have been connected. ⷠBe sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position. [. . . ] Be sure that the steering, shift lever and brake pedal do not get tangled in the cords. It is very dangerous for the cords to become tangled with the gearshift lever during driving. Switch the location you mount the monitor To use the monitor on dashboard: Switch to "FRONT" and connect the blue cord to the parking brake. To use the monitor behind the headrest: Switch to "REAR". Secure the connecting cords away from the seat adjustment rails and the door frame. ⷠMake sure all other electric devices such as brake lights and headlights are working properly after installation is completed. Also check that the indicators turn on and the horn works properly. The numbers in the list are keyed to those in the instructions. If the fuse blows again after replacement, there may be an internal malfunction. Use a fuse with the specified amperage rating. ⷠIn order to prevent rattling from the vibration of the car, make sure that the back or the bottom of the cradle is touching the mounting surface when mounting the monitor unit. The monitor can be installed behind the headrest by using the supplied headrest installation kit. Seat types on which you can mount the installation kit A seat with rods spaced between 42 mm and 192 mm. Note Depending on the seat type, it may not be possible to mount this unit. -- in a hot place, subject to direct sunlight, near a heater or in a car with the windows closed (especially in summer) or in an extremely cold place. Clean the mounting surface well with the cleaning cloth. ⷠWarm the mounting surface and the doublesided tape to a room temperature of more than 20 °C and then press the base of the stand with the double-sided tape attached, firmly against the mounting surface. ⷠWhen tightening the screws, make sure that the nearby wiring does not get caught. ⷠWhen drilling holes on the mounting surface, make sure that there is nothing on the other side. Install the cradle 3 onto the installation kit 7, and tighten the screw on the bottom using things like a coin. [. . . ] You can install the monitor either on the dashboard or behind the headrest. Switch REAR/FRONT on the connection box to locate the position you mount the monitor. see the figure in the "Connections" section. Make sure the installation surface and monitor position are suitable before beginning installation. [. . . ]