User manual SONY XVM-5

[. . . ] If you try to install this unit by yourself, do it properly, referring to the installation and wiring diagrams in this operating manual. Before installation, be sure to turn the ignition switch to the OFF position or take the key out. Installing this unit with the ignition on may cause battery drain or a short circuit. Do not damage any pipes, tubes, the fuel tank or electric wiring when installing this unit. [. . . ] * The reverse position of the display monitor You can close with the LCD surface out after turning around 180 degrees, and images on the screen can be turned upside down by pressing (REVERSE) on the monitor. Before closing the display monitor, make sure that the monitor is turned and facing the enclosure (you will hear a click). Each time you press (REVERSE) on the monitor, the reverse screen mode switches between on and off. Card remote commander RM-X122 For DVD operations: When a Sony mobile DVD player is connected to this unit, you can control the basic functions with the card remote commander. Sony DVD changer DVX-100 is not controllable with this card remote commander. Press (OPEN) to open the display monitor, then press (POWER) to turn on the monitor. Tip If your car has no ACC (accessory) position on the ignition key switch, and the POWER SELECT switch is set to the B position, the monitor does not turn on by pressing (POWER) on the card remote commander (page 6). Close the display monitor until it clicks. Be careful not to catch your finger in the display monitor when closing. Do not put any foreign objects between the LCD panel and the enclosure when closing. Adjusting the tilt and swivel This display monitor can be adjusted within the angles shown. You can make connections shown in A area. Please ask a qualified technician for the other connections. Be sure to fasten PS one® in a safe place securely. For your safety, do not use PS one® while driving your car. Other voltages may cause malfunction, or damage PS one®. When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. if the fuse blows , check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. ) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. [. . . ] These are called bright spots, and can happen with any LCD. the LCD panel is highly sophisticated , and more than 99. 99 % of the segments used in the panel are flawless. However, there is a possibility that less than 0. [. . . ]