User manual SONY XVM-6000

[. . . ] it may cause injury or damage to the unit. - Take care not to bump your head against the unit when getting up from the back seat. - Take extra care not to wind the wire of the headphones around your neck avoiding injury or suffocation in the event of a sudden movement of the vehicle. - Keep small articles out of the reach of children. [. . . ] To turn off the monitor, follow the operations below: ­ Press (POWER) on the monitor. If the power is left on, it will cause battery drain. * The reverse position of the display monitor You can close with the LCD surface out after turning around 180 degrees, and images on the screen can be turned upside down by pressing (REVERSE) on the monitor. Before closing the display monitor, make sure that the monitor is turned and facing the enclosure (you will hear a click). Each time you press (REVERSE) on the monitor, the reverse screen mode switches between on and off. Card remote commander RM-X122 For DVD operations: When a Sony mobile DVD player is connected to this unit, you can control the basic functions with the card remote commander. Sony DVD changer DVX-100 is not controllable with this card remote commander. Press (OPEN) to open the display monitor, then press (POWER) to turn on the monitor. Tip If your car has no ACC (accessory) position on the ignition key switch, and the POWER SELECT switch is set to the B position, the monitor does not turn on by pressing (POWER) on the card remote commander (page 6). Close the display monitor until it clicks. Be careful not to catch your finger in the display monitor when closing. Notes on the locations for PS one® Do not set PS one®: -- on a dashboard, or in a place subject to direct sunlight. -- in a place to subject to temperature extremes (below 5°C or above 35°C). You can make connections shown in A area. Please ask a qualified technician for the other connections. Be sure to fasten PS one® in a safe place securely. For your safety, do not use PS one® while driving your car. Other voltages may cause malfunction, or damage PS one®. When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. if the fuse blows , check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. [. . . ] These are called bright spots, and can happen with any LCD. the LCD panel is highly sophisticated , and more than 99. 99 % of the segments used in the panel are flawless. However, there is a possibility that less than 0. [. . . ]