User manual SONY ZS-D5

[. . . ] 3-867-185-11 (1) Personal Audio System Operating Instructions ZS-D5 ©1999 by Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. Information For customers in the United States This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Press SLEEP to display "SLEEP. " Press SLEEP to select the minutes when the player goes off automatically. Each time you press the button, the indication changes as follows: "10" n "20" n "30" n "60" n "90" n "120" n no indication. If 4 seconds have passed after you pressed SLEEP, the minutes in the display are stored in memory. When the preset time has passed, music stops and the player goes off automatically. To cancel the sleep function Press SLEEP to make "SLEEP" disappear from the display. To change the preset time Do the steps 2 and 3 again. The Timer 31 Timer-recording radio programs You can set timer to record the radio at a certain time. You can also record the sound of the component connected to the LINE IN jack, using the timer. Make sure you have set the clock (see "Setting the clock" on page 28). TIMER STANDBY DISPLAY ENTER MEMORY =, + DIR MODE Note You cannot preset recording timer and waking up timer (page 29) at the same time. Tips · We recommend that you use AC power as the power source for optimum recording quality. · When you receive the AM program in step 1, press r/P to check if the noise is heard. If so, press MODE·MONO/ ST ISS to select the position that most decreases the noise. Before you begin, make sure the t (clock) indication is not lit in the display. If it is lit, press STANDBY. 1 2 Tune in the radio station and insert a blank tape into the tape compartment with the side you want to record on facing forward. Press DIR MODE to select recording direction of the tape. display One side Both sides 3 Press TIMER to display the t indication. Do the following operations by checking the display window. 4 Press = or + to display "RAdIO" "REC, " and press DISPLAY ENTER MEMORY. 32 The Timer Tip If you made a mistake, press CANCEL. The setting entered last will be cleared. Re-enter it. 5 Set the timer to the hour and the minutes you want to start recording. 1 Press = or + to set the hour and press DISPLAY ENTER MEMORY. 2 Press = or + to set the minutes, and press DISPLAY ENTER MEMORY. 6 7 Set the timer to the hour and the minutes you want to stop recording. (Do as step 5. ) Press = or + to set the volume you want, and press DISPLAY ENTER MEMORY. The Timer Tips · To exit the standby mode, press STANDBY twice to make the t indication disappear. · The preset settings remain until you reset them. · When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made. · The display window does not light while the recording timer is on. 8 Press STANDBY. The power goes off and the player enters the standby mode. [. . . ] n Record on TYPE I (normal) or TYPE II (high position) tape and play. Tape Player continued Additional Information 43 Troubleshooting (continued) Symptom The timer does not operate. Remedy · Make sure the time on the clock is correct. · Replace all the batteries in the player including the back-up batteries with new ones if they are weak. · Check to see if the AC power had been cut off. · Make sure the tape has not wound to the end. [. . . ]