User manual SONY ZS-M30

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. Notice for customers in the United Kingdom A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or or mark) BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] You can label both MDs and tracks during synchronized recording of a whole CD (page 6) or the tracks you programmed (page 20). ⷠYou can only label the tracks during synchronized recording of a single track ­ REC IT (page 19). During synchronized recording of a whole CD or the tracks you programmed You can label an MD or a track with up to 40 characters. If you want to label more than 25 tracks, label the tracks after recording (page 32). During recording, press EDIT repeatedly until "Disc Name" or "Track Name" appears in the display, and press YES· When you label a track, select "Track Name". When you label a track, turn the jog dial to select a track number in a CD, and press YES· eNTER. When you label an MD, proceed to step 3. Turn the jog dial clockwise or counterclockwise to select the character, and press k to make the cursor shift rightward. @_`+ ­', /: (space) Note After you stop editing, do not disconnect the mains lead or move the player while "TOC EDIT" is flashing in the display. If you do so, editing may not be done properly. According to steps 3 and 4 in "Labelling during recording", label a track. You can also use the following buttons: Button to use DISPLAY Function Each time you press the button, the character changes as follows: Uppercase letters t Lowercase letters t Numbers and symbols. Repeat step 3 to complete an entire name. You can input up to 100 characters for each label. When you label an MD, insert the MD you want to label and stop operation. When you label a track, play the track you want to label. When you label a track, select "Track Name". To change the name According to steps 1 and 2 on this page, make the disc name or the track name you want to change appear in the display. Replace the old name with a new one, and press YES· eNTER. Tip When using an MD that has been already labelled, a disc name or a track name appears in the display at the time of labelling. Change the name according to steps 3 and 4 on page 31, if necessary, then press YES· The characters you can input using the remote Numbers, letters and symbols are allocated to each number/character button on the remote. Each time you press the button, the character changes in the display as shown in the following table. [. . . ] ⷠMove closer to the player when using the remote. Operation may become unstable depending on the power supply or other causes because this player employs a microcomputer to link each operation. If problems not described above occur, disconnect the mains lead from the wall outlet, and connect it to the wall outlet again after about 20 seconds. (In this case, clock set, timer or preset radio stations are reset to the initial settings. [. . . ]