User manual SONY ZS-M50

[. . . ] To prevent fire or shock hazard, do not expose the player to rain or moisture. Notice for customers in the United Kingdom A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] While playing the MD, press MD ^ the point at where you want to create a new track. If you want to cancel the divide function at this point: PressNO· Note After you stop recording, do not disconnect the mains lead or move the player while "TOC EDIT" is flashing in the display. If you do so, recording may not be done properly. "Complete" appears in the display for a few seconds after the track is divided. The original track only has the track name, while the new track has no name (this happens only when the track you divided had its track name). One track is added to the music calendar. You can combine two adjacent tracks into a single one. Using the combine function, you can combine a number of fragmented recordings or delete the unnecessary track marks. All tracks following the combined track are renumbered. If you repeat editing on the MD, you may not be able to combine the tracks. This is due to the system limitations of the MD (page 68), but not caused by malfunction. If "Cannot Edit" appears in the display, you may be trying to combine the tracks on the first track. You cannot use the combine function on the first track. Track number Combining B and C are combined into one track. Example: To combine tracks B and C, play the track C. If you want to cancel the combine function at this point: PressNO· Note After you stop recording, do not disconnect the mains lead or move the player while "TOC EDIT" is flashing in the display. If you do so, recording may not be done properly. "Complete" appears in the display for a few seconds after the tracks are combined. If both of the combined tracks had track names, the name of the latter track is erased. The total number of tracks in the music calendar decreases by one. After you move the track, the track numbers are renumbered automatically. Note After you stop recording, do not disconnect the mains lead or move the player while "TOC EDIT" is flashing in the display. [. . . ] Make sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. Move closer to the player when using the remote. Operation may become unstable depending on the power supply or other causes because this player employs a microcomputer to link each operation. If other troubles not described above occur, disconnect the mains lead from the wall outlet, then connect it again after about 20 seconds. [. . . ]