User manual SONY ZS-S4IPBLACK

[. . . ] 4-107-422-11(1) This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Important Safety Instructions 1) 2) 3) 4) 5) 6) 7) Read these instructions. Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. Radio section Frequency range FM: 87. 5 - 108 MHz AM: 530 - 1 710 kHz Antennas FM: Telescopic antenna AM: Built-in ferrite bar antenna On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. Power sources Cleaning the cabinet · Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. General Speaker Full range: 8 cm (3 1/4 inches) dia. , 16 , cone type (2) Outputs Headphones jack (stereo minijack): For 16 - 32 impedance headphones Input AUDIO IN jack (stereo minijack) Power output 2 W + 2 W (at 16 , 10% harmonic distortion) Power requirements For player: 120 V AC, 60 Hz 9 V DC, 6 R14 (size C) batteries Power consumption AC 16 W Battery life For player: 1 to AC IN 2 to a wall outlet Connect the AC power cord or insert six R14 (size C) batteries (not supplied) into the battery compartment . Notes · Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to remove the CD from the player. · To use the player on battery power, disconnect the AC power cord from the player. FM reception Sony R14P: approx. 400 × 169. 7 × 224 mm (w/h/d) (15 3/4 × 6 11/16 × 8 13/16 inches) (incl. batteries) Supplied accessory AC power cord (1) Remote control (1) Exchangeable lid (1) Design and specifications are subject to change without notice. Preparing the remote Insert two R6 (size AA) batteries (not supplied). Replacing batteries With normal use, the batteries for the remote should last about six months. When the remote no longer operates the unit, replace all the batteries with new ones. Optional accessory Sony MDR headphones series Before using the unit To turn on/off the power Press POWER . Falling asleep to music 1 Play the music source you want. 2 Press SLEEP on the remote to display "SLEEP. " 3 Press SLEEP on the remote to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" "90" "120" "OFF" "10" "20" "30". To adjust the volume Press VOLUME +, ­ . To listen through headphones To reinforce the bass sound Connect the headphones to the (headphones) jack . "MEGA BASS" appears in the display. Press or then press DISPLAY·ENTER (ENTER on the remote) for the tracks (up to 20) you want to program in the order you want. Then press CD ( on the remote). Playing order 5 Press DISPLAY·ENTER (ENTER on the remote). iPod There is no audio. · Make sure the iPod is connected firmly. · Adjust the VOLUME +, - . Shuffle play "SHUF" Repeat tracks "SHUF" in random and " " order Program play "PGM" VOLUME + , iPod & iPhone and CD have a tactile dot. Stop playback Go to the next track Go back to the previous track Locate a point while listening to the sound Locate a point while observing on the iPod display Select a menu Operation is impossible. Playing preset radio stations 1 Press RADIO·BAND·AUTO PRESET (BAND on the remote) to select the band. · Make sure the iPod is connected firmly. Cannot charge iPod. · You cannot charge the iPod when the unit is using DC power supply. · You cannot charge the iPod when "DC OUT" does not appear on the display in radio mode. 2 Press PRESET + or ­ to tune in the stored station. you find the point. (forward) or (backward) in pause and hold it until you find the point. Press MENU/MODE (MENU on the remote) and or to select a menu, and then press ENTER . Press MENU/MODE (MENU on the remote). CD player Programed track Using the display iPod mode To use iPod backlight The CD does not play or "no dISC" is displayed even when a CD is in place. · Place the CD with the label surface up. [. . . ] For details, refer to the instruction manual of the component to be connected. The picture of your TV becomes unstable. · If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV. Remote The remote does not function. · Replace all the batteries in the remote with new ones if they are weak. · Make sure that you are pointing the remote at the remote sensor on the unit. · Remove any obstacles in the path of the remote and the unit. · Make sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light. [. . . ]