User manual SONY ZS-Y3L

[. . . ] ⷠIf you are using the remote while listening to MW/LW radio, noise may be heard. 6 µW (This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture. To prevent fire or shock hazard, do not expose the player to rain or moisture. The picture of your TV becomes unstable. [. . . ] If you should lose the fuse cover, please contact your nearest Sony service station. 2 , cone type (2) Input LINE IN jack (stereo minijack): Minimum input level 330 mV Outputs Headphones jack (stereo minijack): For 16 - 64 impedance headphones OPTICAL DIGITAL OUT (CD) (optical output connector): Wavelength 630 - 690 nm Maximum power output 5W Power requirements For Personal Audio System: 230 V AC, 50 Hz 9 V DC, 6 R14 (size C) batteries For remote control: 3 V DC, 2 R03 (size AAA) batteries Power consumption AC 16 W Battery life CD playback Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. ⷠDo not place the player on an inclined or unstable place. ⷠDo not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. ⷠIf the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. ⷠSince a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. If you need to open the CD compartment before you replace the batteries, slide the CD LID OPEN switch on the bottom of the player with a sharp instrument or tool. Clean the CD, or replace it if the CD is badly damaged. ⷠPlace the player in a location free from vibration. ⷠClean the lens with a commercially available blower. ⷠThe sound may drop out or noise may be heard when using poor quality CD-Rs/CDRWs or if there is a problem with the recording device or application software. If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. Batteries) Supplied accessories Mains lead (1) Remote control (1) Design and specifications are subject to change without notice. Connect the mains lead A or insert six R14 (size C) batteries (not supplied) into the battery compartment B . Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. ⷠTo use the player on batteries, disconnect the mains lead from the player. ⷠWhen you operate the player on batteries, you cannot turn on the player using the remote. [. . . ] To turn on/off the power Press MODE until the selected mode disappears from the display. The backlight in the display does not light while the sleeping timer is on. To check the programmed track and playing order in the display To check the order of tracks before play, press DSPL/ENT/MEM. Every time you press the button, the track number appears in the programmed order. [. . . ]