User manual SONY ZS-2000

[. . . ] 3-046-451-42 (1) Personal Audio System Operating Instructions ZS-2000 ©2000 Sony Corporation Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] 2 Press TUNE·TIME SET + or ­ to set the minutes and press DISPLAY·ENTER MEM. 5 Press TUNE·TIME SET + or ­ to set the volume you want, and press DISPLAY·ENTER MEM. Tips · To exit the standby mode, press STANDBY to make the indication disappear. · The preset settings remain until you reset them. 6 Press STANDBY. The indication lights up and the power goes off; the player enters the standby mode. At the preset time, the power will go on and music will play. Then the power will go off after 1 hour, and the player will enter the standby mode again. To check/change the waking up timer settings Press TIMER, then DISPLAY·ENTER MEM. Each time you press DISPLAY·ENTER MEM, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and re-enter it. To use the player before a timer playback starts If you turn on the player, you can use it as usual (in case of the radio, if you listen to the station which is different from the one you tuned in step 1 on page 21, you will hear that station at the preset time). Turn off the player before the preset time. 22 The Timer To stop play Turn off the power. Tip Every time the player turns on using the SNOOZE function, the volume will be turned up one level. To doze for a few more minutes Press SNOOZE. "Snooze" appears in the display and the power goes off. The player turns on automatically after about 5 minutes. You can repeat this process by pressing SNOOZE. The Timer To cancel the snooze function Press POWER to turn on the power. The Timer 23 Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90 and 120 minutes, allowing you to fall asleep while listening to music. SLEEP Tips · The display window dims while the sleep timer is on. · You can combine the wake up timer with the sleep timer. Set the wake up timer first (page 21), turn on the power, and then set the sleep timer. · You can prepare the different music for the wake up timer and the sleep timer. However, you cannot store different radio stations. · You can set different volume for the wake up timer and the sleep timer. For instance, you can sleep at lower volume and wake up at higher volume. 1 2 3 Play the music source you want. Press SLEEP to display "SLEEP. " Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" t "90" t "120" t no indication t "10" t "20" t "30". If 4 seconds have passed after you pressed SLEEP, the minutes in the display are stored in memory. When the preset time has passed, music stops and the player goes off automatically. To cancel the sleep function Press SLEEP to make "SLEEP" disappear from the display. [. . . ] · Place the CD with the label surface up. · Take out the CD and leave the CD tray open for about an hour to dry moisture condensation. · Press x to switch the function of the player to "CD". · Clean the CD, or replace it if the CD is badly damaged. [. . . ]