User manual SOULET ARNO 215045

[. . . ] The term "power tool" in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. [. . . ] Be careful of the bit rotating direction and the feed direction. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. Do not smear the tool base carelessly with thinner, gasoline, oil or the like. they may cause cracks in the tool base. Draw attention to the need to use cutters of the correct shank diameter and which are suitable for the speed of the tool. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Always use the correct dust mask/respirator for the material and application you are working with. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. To start the tool, depress the lock button and pull the switch trigger. For continuous operation, pull the switch trigger and then depress the lock button further. To stop the tool, pull the switch trigger so that the lock button returns automatically. After releasing the switch trigger, the lock-off function works to prevent the switch trigger from being pulled. CAUTION: Hold the tool firmly when turning off the tool, to overcome the reaction. For model RP1801F, ARNO 215045 only This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after switch trigger moving to the "OFF" position, have tool serviced at a Makita service center. For model ARNO 215045 only Possible to get fine finish, because the rotating speed is kept constantly even under the loaded condition. Additionally, when the load on the tool exceeds admissible levels, power to the motor is reduced to protect the motor from overheating. When the load returns to admissible levels, the tool will operate as normal. Soft start because of suppressed starting shock. [. . . ] Moving the tool forward too slowly may burn and mar the cut. The proper feed rate will depend on the bit size, the kind of workpiece and depth of cut. Before beginning the cut on the actual workpiece, it is advisable to make a sample cut on a piece of scrap lumber. This will show exactly how the cut will look as well as enable you to check dimensions. [. . . ]