User manual SOUNDCRAFT 600

[. . . ] Carry out the following instructions: 1. Download and install the V3. 4. 2 software. Start and then close Cobranet Discovery. [. . . ] In windows explorer, navigate to C:\Program Files\Cirrus Logic\CobraNet Discovery. Open the file cndisco. ini using the `Open with. . . ' command and use Notepad to open. Add the exact text shown highlighted in the screenshot below. The new text has to be in the section [Configuration] ­ the exact position of it within the section in relation to other lines of text is unimportant. (The other text in this file may differ from what is shown in the screenshot ­ this is not a problem). Restart Cobranet Discovery. ® 2. Setting up the Ethernet port on the Laptop PC. First the laptop PC needs to have its network port configured to have a fixed IP address in order to communicate with the CobraNet® card: 1. On the laptop: Start\Connect to\Show all connections\Local Area connection Right-click the Local Area Connection icon and select Properties: 2. In the IP Address range enter values as above, and then check the `Enable Auto Assignment box'. Click OK and return to the main Discovery window. Note ­ you only have to carry out this step the first time you connect to the Vi6 card. 3. You should now see the Vi6 CobraNet® module in the Discovery window, with an IP address similar to that shown: The IP address is only used for the purposes of connecting to the configuration computer, so what the actual address is does not matter, as long as it is in the same subnet as the laptop's Ethernet port ­ if you've followed the previous instructions, it will be! 4. To configure the CobraNet card, click on the Vi6 device to select it, then choose Tools/Configure ­ or just double-click the device. The Configuration box appears, and the Advanced Configuration box can be opened by clicking `Advanced'. 5. The bundle numbers can now be changed as required by selecting one of the four transmit or receive bundles and either clicking the `Configure' button, or just double-clicking the bundle: IMPORTANT!The Vi6 CobraNet® card is set from the factory to have 4 transmit bundles (32 channels) and no receive bundles active. The number of transmit and receive channels is also set on the CobraNet card PCB on DIP switches. [. . . ] The number of transmit and receive channels is also set on the CobraNet card PCB on DIP switches. These switches determine how many channels are available in the Vi6 Input and Output patching touchscreens, Therefore if the number of transmit and/or receive channels is changed from the default, the DIP switches should also be changed to match. The SubFormat parameter allows the bit depth to be changed to match the network ­ but note that if this is changed to 24 bits, it is not possible to use all 8 channels in the bundle. 6. Changing the Latency, sample rate and card name The Advanced Configuration dialogue box is used to set the Latency and Sample rate of the Vi6 CobraNet card (this is the parameter called `modeRate Control') These MUST match the other devices in the network, otherwise the system will not work. [. . . ]