User manual SOUNDCRAFT MBI SERIES 5 V2

[. . . ] With the Spirit Analogue or Mic/Line interface, the 8 ISIS inputs can be connected to the 328 8 group outputs. Analogue outputs from the ISIS can be connected to any analogue input on the console. Spirit Digital 328 v2 2 Digital 328 Setup Wordclock To ensure that the Digital 328 is configured to be the wordclock master, enter the 328 Menu pages by pressing the <MENU> button on the right hand side of the LCD display. [. . . ] Here, Internal Clock must be selected as the source, at a sample rate of either 44. 1kHz or 48kHz, depending on the rate at which you wish to work. Use the encoder to select, press <ENTER> to set the sample rate and <MENU> to return to the menu pages. 2 <Wordclock Src. > Internal:44. 1kHz S/PDIF Input The S/PDIF Input on the console must be routed to a suitable destination. The available options are one of the 2 Stereo Inputs, one of the 2 FX Returns or as a Digital 2 Track Return. Note that selecting one of these destinations will override an analogue signal present at that input. So, the input which should be used will depend on which other inputs are connected. It is likely that the most suitable input would be either Stereo 2 or as a digital 2 Track Return. For example < SPDIF Output > Src From: AUX1/2 or < SPDIF Output > Src From: MIX NOTE In addition for both S/PDIF Input and Output, an option of `Nowhere' is available as a destination or source. If only a S/PDIF input was required, for example, the output source should be set to `Nowhere'. < SPDIF Input > Route To:NOWHERE < SPDIF Output > Src From:NOWHERE NOTE It is advisable to check the above settings in the 328 when not connected to the ISIS with the S/PDIF connections. Then switch off the system, make the connections and boot the ISIS. Next make the settings in the following section, then boot the 328. Spirit Digital 328 v2 4 Guillemot ISIS Setup Console 8/4 With The 328 Reference will need to be made to the ISIS documentation, and documentation supplied with audio sequencers and other software. Configuring ISIS Clock Source 3 Firstly run the ISIS software application, Console 8/4. This can be activated either from the taskbar or from the Start Menu, as shown below: Once the application is running, the clock source must be set to receive wordclock from the SPDIF input. The setting will revert to internal clock when the PC boots, and so this change must be made before running any audio application with the 328 every time the computer is started. [. . . ] It is advisable to make this change before booting the 328. Guillemot Maxi Studio ISIS Setup Guide 5 Set the ISIS to slave wordclock from the S/PDIF input by selecting the S/PDIF switch within Console 8/4 as illustrated below: The sample rate selected in the 328 Clock Source Sel menu (see page 3) should be indicated beneath the S/PDIF Master Clock switch. Once the settings have been made, the 328 should be booted and the hard disk recording application or other audio software can be started. NOTE ISIS inputs 7 and 8 in Console 8/4 are selectable between analogue inputs 7/8, the S/PDIF input and the CD input. [. . . ]