User manual SOUNDCRAFT VENUE THEATRE V2

[. . . ] The DS2416 outputs can be connected to any 328XD input ­ Stereo 1 for example. The inputs can be derived from any 328XD output, such as a pair of aux sends or the mix output, depending on how you wish to record. 2 Soundcraft 328XD and Yamaha DS2416 328XD CONFIGURATION To configure the 328XD as the wordclock master, enter the 328XD Menu pages by pressing the <MENU> button on the right hand side of the LCD display. [. . . ] Here, the sample rate at which you wish to work is also determined. Select `Internal:44. 1kHz' or `Internal:48. 0kHz', depending on the chosen sample rate: S/PDIF Input The S/PDIF Input on the console must be routed to a suitable destination. The available options are one of the 2 Stereo Inputs, one of the 2 FX Returns or as a digital 2-Track Return. NOTE: Selecting one of these destinations will override an analogue signal present at that input. So, the input which should be used will depend on which other inputs are connected. It is likely that the most suitable input would be either Stereo 2 or as a digital 2-Track Return. Enter the menu pages by pressing the <MENU> button on the right hand side of the LCD display. C-Console provides stand alone control of the DS2416's functions without requiring direct integration into a sequencer package. For further information visit http://www. c-mexx. com. DS2416 Patch Utility The DS2416 Patch Utility is also required. This should also be downloaded from the Yamaha website: This enables the card to be set to slave to the 328XD's master clock. WORDCLOCK Run the patch. exe application. First click the `DIO #1' tab and set the clock source to DI (Digital In) so that the card slaves to the 328XD master clock as shown below: NOTE: Do not close the DS2416 Patch application as the card's clock will revert to its default internal state. 5 Soundcraft 328XD and Yamaha DS2416 CONFIGURING DS2416 S/PDIF I/O NOTE: If using the patch. exe application alone, without an application such as C-Console, it must also be used to activate the DS2416 S/PDIF input. Click on the `Master & InPatch #1' tab and activate the S/PDIF inputs by clicking both S/PDIF switches: The pan controls should also be panned hard left and right and the Stereo output activated: The 328XD SPDIF output will then be routed into the DS2416 card available for hard disk recording and the output will be routed to the 328XD input as selected in 328XD Configuration. C-Mexx C-Console If using C-Mexx C-Console for control of the DS2416, the digital S/PDIF input appears again on channels 19 and 20 but C-Console of course offers far more control. NOTE: patch. exe must still be run and left active in the background if slaving clock from the 328XD. If using the DS2416 as the master clock source, patch. exe does not need to be run. 6 Soundcraft 328XD and Yamaha DS2416 Open C-Console and click View | In Patch | New and ensure that the S/PDIF input is set to be active on channels 19 and 20 as shown (left). [. . . ] If using the DS2416 as the master clock source, patch. exe does not need to be run. 6 Soundcraft 328XD and Yamaha DS2416 Open C-Console and click View | In Patch | New and ensure that the S/PDIF input is set to be active on channels 19 and 20 as shown (left). The 328XD S/PDIF output will now appear on channels 19 and 20 on the DS2416 C-Console control surface as indicated on the following page. [. . . ]