User manual SPORT ELEC BODY CONTROL MINCEUR

[. . . ] ON/OFF key : turns the unit On and Off CAUTION: If you move with accessories attached and a partial loss of contact between electrodes Open the "batteries" compartment, insert three 1, 5 V AA LR6 batteries into the compartment then to close the case. comply with + and - indications (photo II - A page 1). For an optimal use of your apparatus, it is advised to use good quality batteries. The auto-test does not take into consideration the used batteries. [. . . ] The cream facilitates the contact between electrodes and skin. its massaging and electro-conducting properties improve comfort and efficiency of the stimulation. If you wish to buy again some cream, order it directly at 02 32 96 50 50, on our website www. Do not use the belt or the shorts without cream. Do not use any other cream except the one supplied by SPORT ELEC ®Institut Do not leave with the range children. In case of contact with eyes rinse with water. A short press on the " " key puts the device under or off power. Every time under power, the device makes an auto-test on 11 essential parameters at the level of the safety of its operation. During the auto-test segments and pictograms are lit during 0, 5 second. 1 - Make sure that your SPORT-ELEC ® device is switched OFF. 2 - Take the connectors of the unit and plug them to the belt plugs by 2 groups (photo I - F page 2). 3 - Apply a thick layer of the electro-conducting massage cream on your abdominal area and the on the built-in electrodes of the belt (the convex part - photo I - E page 2) 4 - Place the belt on your abdominal muscles in such a way that the electrodes should be centred on your abs. Adjust them using the "stratch" straps making sure that the built-in electrodes are in contact with the skin (photos I page 2 : G - abdominal muscles). STEP 2 : Session start Once your device connected, make yourself comfortably and start your device following the procedure by " Starting the unit " detailed previously in paragraph II. Do not try to increase the intensity too quickly. If the power seems to you too strong, decrease it by pressing briefly on the "-". A long press on the "-" key returns the power to its minimal level. This opreation does not switch off the device. Do not hesitate to place the belt slightly to the left or right (after switching the power key on zero) in order to feel the contractions on the whole area of abdominals. If an electrode hurts or if you feel some tingling, it is necessary to stop the device and to verify whether the electrode is well covered with cream. 1 - Make sure that your SPORT-ELEC ® device is switched OFF. 2 - Take the connectors of the unit and plug them to the shorts plugs by 2 groups (photo I - F page 2). [. . . ] cLEANING AND MAINTENANCE CONDITIONS FOR THE BELT AND SHORTS. SAFETY CHECK Every 24 months, check the following points : 1 - Check for superficial degradation of the equipment 2 - Check proper operation of the unit : * legible display * switch, contact 3 - Measure electric values : * with a 500-ohm load, the current must not exceed 100 V. 4 - Check reliability of accessories : * adhesive electrodes in good condition (no tears, no material defects) * wire of adhesive electrodes in good condition. - Do not dry-clean - Do not use bleach - Clean accessories with a humid sponge soaked with detergent and wipe with a cloth. [. . . ]