User manual SPORT ELEC SELECTION 6 BEAUTE

[. . . ] sPORT-ELEC SELECTION 6 Beauté contains 4 programmes developed by SPORT-ELEC research. The frequencies and pulse widths of each programme have been defined to correspond perfectly to the needs of each of us : - To work the muscle gently and facilitate its recovery after an effort - To improve tissue firmness - To remodel the silhouette In conclusion, depending on our activity, some muscles are developed to a greater or lesser extent, whilst other, less used muscles waste away. There are more than 600 muscles in our bodies. [. . . ] PRECAUTIONS FOR USE * Do not use on the face, * keep out of reach of children, * Seek advice from your doctor : - if you have any electronic or metallic implants (pins, etc. ) in general , - in case of skin disease (wounds , etc. ), * the equipment is not approved for therapeutic use (seek advice from your doctor). Two groups of 3 wires (2 black +1 light blue, 2 grey + 1 light blue) 80 cm in length connect the SPORT-ELEC appliance to the body electrodes (50mm in diameter). Check that the switch of the SPORT-ELEC Selection 6 Beauté is on «O» and the power button are on minimum (fully to the left). open the battery compartment and connect the two 9-volt batteries to the connectors. Insert the batteries into the compartment, and then close the case. START OF SESSION Make sure that the power buttons are set at minimum (pushed to the left). You are now ready to move on, either to muscle building, or to your favourite sport. P2 :ENERGY (Frequency: 3 - 60 Hz) This programme helps you to efficiently firm up your body after a period of inactivity and maintain tissue firmness. p3 : FITNESS (Frequency: 3 - 100 Hz) Harmonises your silhouette. This programme is ideal for working specifically on the zone that you want to reshape. Power supply : 2 9-Volt batteries, type 6LR61 (not provided) DIMENSIONS : 132x59x23 mm WEIGHT : 140 g Classification type BF 86 Vcc/500 INSERTION OF BATTERIES : connect the tags to the batteries and insert the back of the battery by pressing with the thumb. Follow these instructions in the order given to avoid damaging the tags. At the end of the session, put the power buttons on the minimum position and set the switch to «O». Disconnect the electrodes, remove them gently, wet them slightly with a few drops of water and place them carefully on their support. SAFETY INSPECTION - Inspect the following points every 24 months : 1. Check if the unit is operating correctly : * the writing on the housing must be legible * check the switch and contactor. [. . . ] - Do not exceed 30 minutes of muscle work per area and per day. - For optimum use, get ideas from the diagrams shown in this brochure. - You can, if you wish, have two 15-minute sessions, changing the area of the electrodes; for example, 15 minutes for the abdominal muscles and 15 minutes for the buttocks. [. . . ]