User manual SPYDER ELECTRA

[. . . ] Kingman recommends that the customer be at least 18 years of age to purchase this product. Read this manual and air tank warnings before using this product. Any modifications or tampering of original factory parts will void all warranties and liabilities from Kingman. Kingman recommends using a barrel blocking device when the marker is not in operation. [. . . ] It is to stop the trigger from further back travel after it has actuated the micro switch VELOCITY ADJUSTMENT INCREASE / DECREASE VTA028 VTA029 STP028 STP029 To INCREASE your velocity fps using the Allen wrench, turn the Velocity Adjuster / Spring Guide clockwise. To DECREASE your velocity fps using the Allen wrench, turn the Velocity Adjuster / Spring Guide counterclockwise. NOTE: Allen wrench provided in the spare parts kit. NOTE: Velocity Adjuster / Spring Guide doesn’t remove from the rear of the Sticker Plug. NOTE: The velocity of this paintball marker ranges from approximately 240 – 300 feet per second (fps). Velocities will fluctuate or vary due to paintball size, climate condition, altitude, type of air source and variance in spring tension from manufacturing. WARNING • The recommended Velocity speed should be no greater then 300 fps. Not doing so can cause serious injury or death if the velocity is set dangerously high. € Paintball markers are not intended to shoot any person less then 25 feet without eye/face protection. € Never point a loaded marker at any person who is not wearing the proper face protection. € Never at any point should you look down the barrel, whether the marker is loaded or not. € Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law enforcement penalties if property damage is caused by the user.   C/A ON/OFF ADAPTER Adjustment to the regulator output pressure is done through the regulator adjuster knob located at the bottom of the regulator with the use of the wrench provided with the spare parts kit. STEP 1 Loosen the Regulator Adjuster Lock Screw located on the on the Regulator Adjuster Knob. STEP 2 Using the Open End Wrench provided with the spare parts kit, turning the adjuster knob clockwise will decrease the regulator output pressure and turning the adjuster knob counter clockwise will increase the output pressure of the regulator. The regulator output should be no less than 300psi or at least one and a half turn counter clockwise of the Regulator Adjuster Knob from the bottom of the regulator. NOTE: Too low of an output setting from the regulator will result in very low velocity and some recocking issue with the marker. You must have adequate output air pressure from the regulator to avoid starving the marker for air. Too high of an output setting of the regulator will result in excessive air consumption and poor air efficiency. This may also result in dangerously high velocities exceeding the recommended safety limits for playing paintball. STEP 3 After each adjustment to the regulator, you must fire the marker a few times to let the regulator settle to its new output setting. STEP 4 Securing the Regulator Adjuster Lock Screw will prevent the adjuster knob from turning due to vibrations keeping the regulator output setting stable and locked. [. . . ] 6v rechargeable battery, charger, scratches, nicks, normal wear and tear of parts, any modifications, normal fading of anodizing and damage caused by dropping or hitting of products. This warranty shall not apply if it is shown by a Kingman Technician that the consumer caused the defect or malfunction because of misuse. This warranty only covers original factory parts. Any modifications or tampering of original factory parts will VOID warranty and liabilities from Kingman. [. . . ]