User manual STAIRVILLE DMX512

[. . . ] Professional Lighting Technology User Guide Please read these instructions carefully before use 7. Fixture Cleaning The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit's optics. Y Clean with soft cloth using normal glass cleaning fluid. [. . . ] In the unlikely event your unit may require service, please contact your nearest dealer. Installation The unit should be mounted via its screw holes on the bottom of the base. Always ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure and is able to support a weight of 15 kgs for each unit. 2. Technical Specification Power supply - AC 120V~60Hz - AC 230/240/250V~50/60Hz Lamp - ELC 24V 250W Optical system - Standard 15° focused beam angle. Gobo wheel - Independent gobo wheel with 14 gobos plus open and shutter. - Blackout, and strobe speed variable(1~7 flashes per second). Color wheel - Independent color wheel with 11 dichroic mirrors plus white. Movement - Pan : 540° in 2. 8 second. DMX Channels - Standard DMX512 signal addressing and can be controlled by any universal DMX controller. Channel 1 = Shutter Channel 2 = Gobos Channel 3 = Colors Channel 4 = Pan motion Channel 5 = Tilt motion Dimension : 290mm x 330mm x 380mm Weight : 12 kgs 5B 5. 5 DMX512 Connection The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels. 1 2 3 4 DMX512 1 COMMON 3 2 120 ohm 1/4W 1 3 2 INPUT DMX + DMX - OUTPUT Termination reduces signal errors and to avoid signal transmission problems and interference. It is always advisable to connect a DMX terminal. (Resistance 120 ohm 1/4W) between pin2 (DMX-) and pin3 (DMX+) of the last fixture. 1 3 2 1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit. Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to the input of the next unit. The cable can not be branched or split to a `Y` cable. Inadequate or damaged cables, soldered joints or corroded connectors can easily distort the signal and shut down the system. The DMX output and input connectors are pass-through to maintain the DMX circuit, when power is disconnected to the unit. Each lighting unit needs to have an address set to receive the data sent by the controller. The address number is between 0-511 (usually 0 & 1 are equal to 1). The end of the DMX512 system should be terminated to reduce signal errors. [. . . ] Show 2 mode-Fixture is fixed under ceiling. Tilt movement angle 90°. Display normal mode for the fixture putting on the floor. Display inversion mode for the fixture fixing under ceiling. Slave Mode Press the MENU button up to when the is showing on the display. Pressing Focus Adjust Press the MENU button up to when the is blinking on the display. [. . . ]