User manual STANDART HORIZON CP170C

[. . . ] This appliances is intended to be used in household and similar applications such as: - staff kitchen areas in shops, offices and other working environments; - farm houses; - by clients in hotels, motels and other residential type environments; - bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications. If the appliance is used in a manner inconsistent with this it may reduce the life of the appliance and may void the manufacturer’s warranty. Any damage to the appliance or other damage or loss arising through use that is not consistent with domestic or household use (even if located in a domestic or household environment) shall not be accepted by the manufacturer to the fullest extent permitted by law. [. . . ] Proceed as follow to set a delayed start: Select a programme (“STOP” indicator light blinks) Press Start Delay button (each time the button is pressed the start will be delayed by 3, 6 or 9 hours respectively and the corresponding light will blink). Press START to commence the Start Delay operation (the indicator light associated with the selected Start Delay time stops blinking and remains ON). At the end of the required time delay the programme will start. 14 CANCELLING THE PROGRAMME To cancel the programme, set the selector to the OFF position. Re-set the programme selector to the OFF position. EN CREASE GUARD BUTTON The Crease Guard function (Not available on COTTON programmes) minimizes creases as much as possible with a uniquely designed anti-crease system that is tailored to specific fabrics. MIXED FABRICS - the water is gradually cooled throughout the final two rinses with no spinning and then a delicate spin assures the maximum relaxation of the fabrics. DELICATE FABRICS – final two rinses with no spinning and then the fabrics are left in water until it is time to unload. When you are ready to unload, press the "Crease Guard" button – this will drain. WOLLENS/HAND WASH – after the final rinse the fabrics are left in water until it is time to unload and the button indicator blinking. When you are ready to unload, press the "Crease Guard" button, this will drain and spin ready for emptying. tHIS STATUS WILL BE INDICATED BY THE STOP INDICATOR LIGHT FLASHING , THIS LIGHT WILL CONTINUE TO FLASH UNTIL THE MACHINE HAS STARTED OR THE MACHINE IS RETURNED TO THE OFF POSITION. Switch off the washing machine by turning the selector to OFF. 20 BUTTONS INDICATOR LIGHT The indicator light around the option buttons will light when specific options are selected. If you select an option button that is not compatible with the programme required the button light will not illuminate. °C CHARGE DETERGENT ❙❙ Resistant fabrics Cotton, linen Whites with prewash Fast coloureds Cotton, mixed Fast coloureds Non fast coloureds ❙ ● ● 8 90° 60° 40° 30° ● ** ** 8 8 8 ● ● ● ● ● ● Mixed fabrics and synthetics Mixed, resistant Synthetics (nylon, perlon), mixed cotton Fast coloureds with Prewash Fast coloureds Non fast coloureds 4, 5 4, 5 4, 5 2, 5 60° 50° 40° 40° ● ● ● ● ● ● ● ● ● Please read these notes When washing heavily soiled laundry it is recommended the load is reduced to 4 kg maximum. ** STANDARD COTTON PROGRAMMES ACCORDING TO (EU) No 1015/2010 and No 1061/2010 COTTON PROGRAMME with a temperature of 60°C COTTON PROGRAMME with a temperature of 40°C These programmes are suitable to clean normally soiled cotton laundry and they are the most efficient programmes in terms of combined energy and water consumptions for washing cotton laundry. These programmes have been developed to be compliant with the temperature on the wash label on the garments and the actual water temperature may slightly differ from the declared temperature of the cycle. The spin speed may also be reduced, to match any guidelines suggested on the fabric label, or for very delicate fabrics cancel the spin completely this option is available with a spin speed button. When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine. The "ALL 40°"programme has a temperature of 40°C and alternate dynamic phases (the basket that turns) to static phases (fabrics in soak in phase of rest) with a duration programme that almost reaching the 2 hours. The energy consumption for the complete cycle is only 850 W/h. [. . . ] — After cleaning, replace by turning the notch on the end of the filter clockwise. Then follow all procedures described above in reverse order. REMOVALS OR LONG PERIODS WHEN THE MACHINE IS LEFT STANDING For eventual removals or when the machine is left standing for long periods in unheated rooms, the drain hose should be emptied of all remaining water. Although not strictly necessary, it is advisable to clean the detergent, bleach and additives compartments occasionally. [. . . ]