User manual STANTON C314

[. . . ] C. 314 PROFESSIONAL TABLETOP CD PLAYER USER MANUAL IMPORTANT SAFETY INSTRUCTIONS 1. Read Instructions ­ All the safety and operating instructions should be read before this product is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. Heed Warnings ­ All warnings on the appliance and in the operating instructions should be adhered to. [. . . ] LOCK - Shows when Pitch Lock and/or Key Lock are active. SINGLE ­ Controlled by the CTN/SGL button, this indicates when the unit is set to play just one track at a time. When this is not illuminated, the CD will play continuously through all tracks. A. BPM ­ Indicates when Auto BPM is active. To activate, press and hold the TAP button. A. CUE ­ Indicates when Auto Cue is active. To activate Auto Cue, press and hold the SGL/CTN button 49. LOOP ­ Indicates when the CD is in loop mode. RELOOP ­ Indicates when there is a previously set loop, and that the loop is ready to be played again. EFFECT ­ Indicates when an effect is active. PLAY ­ Indicates when the unit is currently playing a CD. HAND ­ Indicates when the touch sensitive surface of the jog wheel is active. PAUSE ­ Indicates the unit is in CUE or PAUSE mode. CUE ­ Indicates the unit is at a cue point and is ready to play. WHEEL INDICATOR ­ This is a visual representation of a vinyl marker, which is traditionally used to mark the location of a certain sound or cue point on a vinyl record. Here, it indicates the play position, rotates during playback in either direction, and stops during cue or pause mode. It also indicates the speed of the forward and reverse search operation. ELAPSED / TOTAL / REMAIN ­ Indicates whether the time shown on the display refers to total remaining time or track remaining time. If either of these are not illuminated, this indicates elapsed track time. 7 SET UP Checking the contents Check that the carton contains all of the following items: · · · · · Tabletop CD player unit Printed user's manual One RCA cable One power cable One fader start / relay cable Installing the Unit · · · · Place the unit on a flat, level surface. Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity. Try to place the unit as far as possible from TVs and tuners, as the unit may cause undesirable interference. The player will work normally when the unit is within 15 degrees of the vertical plane. [. . . ] If the CD player is connected to the left side of the crossfader, playback will start once the fader is moved from the left most position towards the right. The CD player will re-cue itself when the crossfader is brought back to the left most position. Two CD players can be hooked up in this fashion to work on both sides of the crossfader. 12 SPECIFICATIONS 1. POWER SOURCE US: 120V, 60Hz, AC 18W EU: 230V, 50Hz, AC 18W UK: 240V, 50Hz, AC 18W JPN: 100V, 50/60Hz, AC 18W ARG: 220V, 50Hz, AC 18W AUS: 240V, 50Hz, AC 18W 3. [. . . ]