User manual STANTON DIGIPAK PRO V4

[. . . ] DIGIPAK PRO. V4 USER MANUAL IMPORTANT SAFETY PRECAUTIONS 1. Read Instructions ­ All the safety and operating instructions should be read before this product is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. Heed Warnings ­ All warnings on the appliance and in the operating instructions should be followed. [. . . ] To activate Auto Cue, press and hold the SGL/CTN button. LOOP ­ Indicates when the CD is in loop mode. 9 SETUP CHECKING THE CONTENTS C. 324 CONNECTIONS Make sure that the unit and any other equipment in the signal chain are turned off prior to making any connections. Connect the RCA cable to the rear of the unit and to the input on your mixer. Connect the power cable to the rear of the unit and to a proper AC outlet. CAUTION Be sure to use the supplied cables. Using other types of cables may result in damage to the unit. Check that the carton contains all of the following items. Tabletop CD player unit Printed user's manual One RCA cable One power cable One fader start / relay cable INSTALLING THE UNIT Place the unit on a flat, level surface. Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity Try to place the unit as far as possible from TVs and tuners, as the unit may cause undesirable interference. The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not insert or eject properly, or playback may be adversely affected. The unit's LCD screen is designed to be clearly visible within the angles shown in the right figure. Place the unit so that the LCD screen is within this visual range for optimal clarity. To avoid severe damage to the unit, be sure power is OFF when making any connections. Sight point 10 45 OPERATING INSTRUCTIONS UPDATING FIRMWARE Checking Firmware Version Turn the unit off. Hold down the MODE button (under SAMPLE SEQUENCER) while powering up the unit. Release MODE to go back to the normal playback mode. Updating The Firmware Firmware updates may, as necessary, become available from Stanton's website (www. stantondj. com) as downloadable ISO files, which are needed to create a bootable CD. We recommend using Magic ISO Maker (www. magiciso. com) PC software to burn the disc. Once you have burned a bootable disc from the ISO file, insert the CD into the C. 324. The display will read UPDATE, then SUCCESS. The unit will automatically eject the CD once the update is complete. Turn the unit off and back on to complete the update process. REAR C. 324 DO NOT POWER OFF UNIT WHILE DISC IS INSERTED Removing the disc from the drive before powering off will insure that the laser pickup remains properly calibrated over time. Leaving a disc in the device while powering off could also cause the jog wheel sensitivity to shift, as the same "memory" is shared between laser pickup and jog wheel calibration data. See "Jog Wheel Sensitivity "on page 11 for information. BURNING When burning CD-Rs or CD-RWs for the C. 324, it is strongly recommended to set your burner at 8x write speed. [. . . ] MP3 FORMAT Disc Format MP3 Format Disc Writing Method Applicable file extensions ISO9660 Joliet CD-ROM sector format Max. number of files MPEG 1 Layer 3 standard (ISO/IEC 11172-3), which provides for single channel (`mono') and two-channel (`stereo') coding at sampling rates of 32, 44. 1 and 48KHz. MPEG 2 Layer 3 standard (ISO/IEC 13818-3), which provides for similar coding at sampling rates of 16, 22. 05 and 24 KHz. MPEG 2. 5 Layer 3 standard, which provides for similar coding at sampling rates of 8, 11. 025 and 12 KHz. [. . . ]