User manual STANTON PRO-30

[. . . ] Properly connect AC cord to AC power source. Properly connect amplifier, or outboard gear to mixer. Properly set crossfader, channel faders, gain controls, and input selector tog gles. Adjust headphone level and cue mix to the proper level and channel settings. Loose cartridge/headshell connection. [. . . ] Meter mode selector: Determines the setting of the level meter (6). When pressed, cue levels of channels 1 and 2 are displayed. When released, stereo master output signal is displayed. Power switch: Selects power "ON" or "OFF" 9. Fader Start controls: Activate the Fader Start function when connected to a CD player with fader start capabilities (such as the Next!When fader start is engaged, the CD player can be started and paused by the crossfader. This function is defeated while crossfader is reversed. Master level control: Controls the overall signal output level of the Master output 11. Booth level control: Controls the overall signal output level of the Booth output 12. Cue level control: Controls the overall headphone output level. Cue select: 3 position selector switch dtermines what is heard in the headphones, channel 1, 2, or master output 14. Headphone output: Connection for 1/4 inch headphone. Recommended headphone impedance is 32-200 ohms for maximum volume 15. Mic EQ: Individual controls for low and high frequencies equalization with (+/-12 dB) Any changes made to EQ settings will change the overall microphone output level. Mic volume control: Controls the overall mirophone output level 17. Crossfader Reverse: Reverses the direction of the crossfader. The fader start function is defeated while crossfader is reversed. Microphone input: 1/4" connector 19. Ground connector: Connects to the turntable ground connector to eliminate electrical hum. Ground connectors are usually supplied with turntables 20. Phono/CD inputs: Switchable line / phono signal inputs for channels 1 and 2 21. Line inputs: Line signal inputs for channels 1 and 2 22. [. . . ] Spray a small amount of cleaner or lubricant into both ends of the fader and slide the fader back and forth a few times to spread the fluid evenly throughout the fader. Shake and wipe off excess fluid before re-assembling the fader. TE C H N I CA L S P E C I FI C AT I O N S Line inputs: Phono inputs: DJ mic input: Master output: Record output: Headphone output: Frequency Response: Tone Control : Mic Tone: Gain Control: S/N Ratio: T. H. D: Dimension(LxWxD): Weight: 2 (RCA), 150 mV / 47K ohm 2 (RCA), 3 mV / 47K ohm 1 (1/4 inch), 1. 6 mV / 600 ohm 1 (RCA), 1V / 600 ohm 1 (RCA), 350 mV / 600 ohm 1 (1/4 inch), 32 - 200 ohms recommended 20 Hz - 20 kHz, +/- 0. 5 dB + 9/-26 dB (Hi, Mid, Low) Hi/Mid/Lo +/-12 dB 0-20dB Less than 80dB 0. 01% at 1KHz 8. 6" x 12. 2" x 3. 94" (220 x 310 x 100 mm) 8 Lbs (3. 5 Kg) power supply included C RO S S FA D E R R E P L AC E M E N T To replace the cross or channel faders, follow step 1 of the cleaning instructions. Replacement parts are availabe from Next!dealer. WA R R A N T Y This unit has been designed and manufactured using quality components. [. . . ]